Operating Modes And Functions; Interlock Operating Mode - Record FlipFlow Twin User Manual

5
Operation
Key Operation
Press the key sequence as shown
To deactivate, press the key se-
quence again
Prerequisite Operation
The desired operat- Activate/deactivate the operating
ing mode is set. lock with the key
5.4

Operating modes and functions

NOTICE
The TWIN system type consists of one entrance (entrance door) and one exit (exit door). The
TRIPLE system type has an additional middle door. The chapters apply to both system types.
5.4.1

INTERLOCK operating mode

NOTICE
INTERLOCK mode has fewer passage varieties than FLOW mode but offers maximum secur-
ity, even between two arrivals, a time where the number of passengers is low.
Initial state:
– Lighting on.
– Entrance door closed.
– Centre door closed.
– Exit door closed.
– LED strips green.
– Pictogram at entrance green.
– Pictogram at exit red.
Cycle:
– A person is detected by the entrance sensor and the door opens.
– The person enters the tunnel and closes the entrance door if no other person approaches within a
parameterizable period or the maximum number of persons has been reached. Once the system has
decided to close the door, the LED strips at the entrance change to red.
– The LED strips in the centre and at the output flash to indicate to the person that they should wait.
– As soon as the entrance door is closed, the centre door and exit door open and at the same time the
colour of the LED strip in the centre and at the exit changes to green and the LED strip at the en-
trance flashes.
– The person(s) leave(s) the tunnel, the centre door and exit door close.
– In order to increase throughput and reduce possible waiting times, the entrance door opens again
when the exit door is closed and the airlock is empty. After a short waiting period, the entrance door
closes again. If the sensor of the entrance door detects another person, the system returns to its nor-
mal INTERLOCK mode.
– End of cycle
20 / 32
Activate operation lock via keyboard
Capacity
No settings can be made
on the operating unit.
Activating the operation lock with the key
Capacity
No settings can be made
on the operating unit.
Display example
Display example
BAL_FF_TWIN_EN_3V0_REC_121-006454269