Panasonic ES ST6S Operating Instructions Manual page 15

2
2
Press when finished.
When the battery capacity is low
The charge status lamp ( ) blinks once
every second when operating the shaver.
The appliance beeps twice after
switched off.
• You can shave 2 to 3 times after the
charge status lamp ( ) blinks. (This
will differ depending on usage.)
►Using the trimmer
Slide the trimmer handle up. Place at a
right angle to your skin and move
downwards to trim your sideburns.
►Tips for better usage
Apply the trimmer edge perpendicular to skin gently
and move downward slowly.
Trimming sideburns
ES-ST6S_2S_TW.indb 15
Pre‑shave of long beards
►Notes
• The "shaving sensor", which automatically adjusts the
power depending on the beard thickness, will operate.
It will shave with high power on areas where the
beard is heavy, and reduce the power on areas where
the beard is thin, to reduce burden on the skin.
• Before shaving, check that the cleaning shutter is closed.
• After wet shaving, wash the main body with water and
apply oil to the system outer foil.
• Depending on the beard thickness or the amount of
beard trimmings in the shaver head, the shaving
sensor may not react and the driving sound may not
change. This is not abnormal.
• The appliance may not operate in an ambient
temperature lower than approximately 5 °C.
• The shaving sensor may not respond depending on
the type and quantity of the shaving gel or the quantity
of the foam. This is not abnormal.
• To prevent erroneous operation, place your fingers on
the finger rest while using the shaver.
15
2020/12/22 16:48:49