After approximately 5 seconds, the flashing
stops and the display shows the time of
For time change you must not set an
automatic function (Duration
) at the same time.
• Remove all parts from the appliance.
• Clean the appliance before first use.
Caution! Do not use abrasive cleaning
agents! This can damage the surface.
Refer to chapter "Care and Cleaning".
HOB - DAILY USE
Warning! Refer to "Safety information"
IGNITION OF THE BURNER
Warning! Be very careful when you
use open fire in kitchen environment.
Manufacturer decline any responsibility
in case misuse of the flame
Always light the burner before you put
To light the burner:
1. Turn the control knob counterclockwise
to the maximum position (
push it down.
2. Keep the control knob pushed for ap-
proximately 5 seconds; this will let ther-
mocouple to warm up. If not, the gas
supply will be interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner does not
light, check if the crown and its cap are
in correct positions.
Set an oven to maximum temperature and
run an empty oven for 1 hour, to burn off
any residue from the cavity surface. Acces-
sories can become hotter than in normal
use. During this period an odour can be
emitted. This is normal. Make sure the
room is well ventilated.