Electrolux EKG603202X User Manual page 23

A
B
C
Warning! The gas bayonet must be in
mark area.
Dimension
A
B
C
D
E
PRESSURE TEST
The Rapid injector is used as a pressure
test point.
1. Connect the pressure gauge to the
Rapid injector.
2. Examine the supply pressure by turning
the Rapid burner and one other burner
fully on, and lighting them. The pressure
must be:
a) 20 mbar for Natural Gas
b) 29 mbar for LPG, butane only
c) 37 mbar for LPG, propane only.
3. Turn the taps off and disconnect the
pressure gauge.
4. Make sure that all burners work correct-
ly.
CHECKING THE GRILL
1. Put in the grill pan containing the grid.
2. Light the grill burner by turning the grill
control knob to the symbol
3. Release the knob when the burner
comes on.
CHECKING THE HOB BURNERS
1. Lift the lid.
2. Put in the burner crowns and caps.
3. Put in the pan supports.
4. Check each of the burners in turn by
E
5. Release the knob when the burners
D
CHECKING THE LID SHUT-OFF
C
DEVICE
1. Lift the lid.
2. Light one of the hob burners.
3. Close the lid. There should be no gas
4. Turn the burner off and lift the lid. The
mm
250
680
50
CHECKING THE MAIN OVEN
250
1. Turn the gas oven control knob to the
580
2. When the oven burner comes on, the
3. When the FSD heat sensor is heated
4. After 1 minute make sure that the flame
5. Set the oven control knob to
6. Turn the control knob off and check that
ELECTRICAL INSTALLATION
.
This appliance is supplied with a main plug
and a main cable.
Make sure that they are correctly seat-
ed.
turning the burner control knob to the
symbol .
come on.
supply to the hob burners. The burner
goes out.
gas supply should be restored to the
hob burners, when you turn the knob
on.
symbol .
gas at first flows to the oven burner
slowly, at the FSD by-pass rate.
sufficiently, it opens the FSD valve. The
main gas stream flows to the burner.
covers the full width of the burner and is
stable.
close the oven door. After about 10 mi-
nutes the flame size should decrease.
the oven flames go out.
Warning! Only a qualified and
competent person must do the
electrical installation.
The manufacturer is not responsible if
you do not follow safety precautions
from chapter "Safety information".
electrolux 23
and