Advertisement
PROCOM 2
AIRCRAFT INTERCOM
USER INSTRUCTIONS
INSTALLATION
(Refer to the System Configuration drawing)
Plug the ProCom 2 (PC 2) into the aircraft radio or audio panel jacks.
NOTE: If the aircraft radio does not provide sidetone, the pilot will not be able to hear himself or herself
in the headset during aircraft-to-tower transmissions.
Plug pilot and copilot (or passenger) headphone and microphone plugs into the appropriate jacks on the top panel
of the PC 2.
Push To Talk
(PlT)
Swltch Notes
1. If the aircraft has a built-in pilot yoke switch, it is not necessary to use the pilot PTT jack on the PC 2.
However,
it
is important that the aircraft radio or audio panel microphone jack tip be wired so that
keying the transmitter with the built-in yoke switch will also ground the jack tip. This signal is then
sensed by the PC 2 (via the Ytable microphone/PTTplug) to cause proper operation of the intercom
during transmission.
2. If the aircraft has a built-in copilot yoke switch, it should not be used. lf copilot PTT capability is
desired, use a portable PTT switch plugged into the copilot PTT switch jack on the PC 2.
3. If poltable PTT switches are used,
do
not plug microphones into them, as the PTT switches will have
to be pressed to talk over the intercom. Plug microphones into the PC 2 microphone jacks only.
Connect an extemal m s i c source to the rear panel MUSIC INPUT jack of the PC 2 using a 0.140-inch (3.6 mm)
stereo "miniplug."
Use one of two methods to provide power to the PC 2 intercom:
For internal power operation, install a 9-~0lt battery in the side compartment of the PC 2.
For external power operation, use an optional aircraft cigarette lighter cable (Telex Catalog Number 96513-
000). It is recommended that you use a 100 mA (fast blo) fuse in the external power source. Plug the cable
into the aircraft cigarette lighter and into the AUX POWER jack on the rear panel of the PC 2.
CAUTION
Ensure that the polarity of the external power is as shown in the figure
below. lrrpmper connection may result in damage to the PC 2.
AUX
POWER
12-28
VDC
@
100MA
O
Copyright Telex Communicalions. Inc. All tights resewed.
TELEX,
Advertisement
Table of Contents
Related Manuals for Telex PROCOM2
Summary of Contents for Telex PROCOM2
- Page 1 For internal power operation, install a 9-~0lt battery in the side compartment of the PC 2. For external power operation, use an optional aircraft cigarette lighter cable (Telex Catalog Number 96513- 000). It is recommended that you use a 100 mA (fast blo) fuse in the external power source. Plug the cable into the aircraft cigarette lighter and into the AUX POWER jack on the rear panel of the PC 2.
- Page 2 AIRCRAFT CIGARETTE LIGHTER opTloNA$ POWER CABLE PILOT HEADSET PORTABLE PILOT PTT SWITCH Leave the aircraft radio and music source off, and set the PC 2 locking power switch to the ON position by pulling outward on the switch and pushing it upward. Tum the SQ (squelch) control fully clockwise.
- Page 3 compare it to the volume level when talking on the intercom. If there is a difference in levels, adjust the equalization trimmer (labeled RADIO) on the rear panel of the PC 2 until the radii level is the same as the intercom level. Set the power switch to OFF (FAILSAFE) when the intercom is not in use to consewe battery power.
Need help?
Do you have a question about the PROCOM2 and is the answer not in the manual?
Questions and answers