Table of Contents
Advertisement
Figure 77. Removing enclosure end caps
2. Align the enclosure with the front of the rack cabinet.
3. Carefully slide the enclosure into the rack along the rails until the enclosure is fully inserted.
See Figure 78 on page 68.
Note: The rails are not designed to hold an enclosure that is partially inserted. The enclosure must
always be in a fully inserted position.
Figure 78. Inserting the enclosure
4. Secure the enclosure with screws in the rack mounting screw holes.
(See Figure 78 on page 68 and Figure 79 on page 69.)
5. Reinstall the left and right end caps.
See Figure 79 on page 69. The left end cap has indicator windows that align with the status LEDs
(light-emitting diodes) on the edge of the enclosure.
a) Ensure that the serial number of the end cap matches the serial number on the rear of the
enclosure.
b) Fit the slot on the top of the end cap over the tab on the chassis flange.
c) Rotate the end cap down until it snaps into place.
d) Ensure that the inside surface of the end cap is flush with the chassis.
68 FlashSystem 5100 : Quick Installation Guide for MTM 2078-4F4, 2078-4H4, 2078-12G, 2078-AFG,
2078-24G, 2078-A9G, 2078-92G, and 2078-UHB
Advertisement
Table of Contents
