Table of Contents
Advertisement
Table 6. Selecting bracket pins for your rack
Mounting holes
Round, unthreaded
Square
4. At each end of the rail, grasp the tab
See Figure 7 on page 13.
Figure 7. Opening the hinge brackets
5. Align the holes in the rail bracket with the holes on the front and rear rack cabinet flanges.
Ensure that the rails are aligned on the inside of the rack cabinet.
6. On the rear of the rail, press the two bracket pins into the holes in the rack flanges.
7. Close the rear hinge bracket to secure the rail to the rack cabinet flange.
See Figure 8 on page 13 .
8. On the front of the rail, press the two bracket pins into the holes in the rack flanges.
9. Close the front hinge bracket to secure the rail to the rack cabinet flange.
10. Secure the rear of the rail to the rear rack flange with two black M5 screws.
Figure 8. Installing the side rail
11. Repeat the steps to secure the opposite rail to the rack cabinet.
12. Repeat the procedure to install rails for each additional control enclosure.
Bracket pins
Use the preinstalled medium pins.
Unscrew the medium pins and replace with the large pins that are
supplied with the rails.
1
and pull firmly to open the hinge bracket.
Chapter 2. Installing the system hardware 13
Advertisement
Table of Contents
