Table of Contents
Advertisement
Quick Links
Programmable atmospheric pressure transmitter
© Copyright: COMET SYSTEM, Ltd.
It is prohibited to copy and make any changes in this manual, without explicit agreement
of company COMET SYSTEM, Ltd. All rights reserved.
COMET SYSTEM, Ltd. makes constant development and improvement of their products.
Manufacturer reserves the right to make technical changes to the device without previous notice.
Misprints reserved.
Manufacturer is not responsible for damages caused by using the device in conflict with this
manual.
To damages caused by using the device in conflict with this manual cannot be provide free repairs
during the warranty period.
Read carefully instruction manual before the first device connection.
Contact address of this device's producer:
T2214
with 0 to 10 V output
Instruction Manual
COMET SYSTEM, s.r.o.
Bezrucova 2901
756 61 Roznov pod Radhostem
Czech Republic
www.cometsystem.com
Advertisement
Table of Contents
Related Manuals for Comet System T2214
Summary of Contents for Comet System T2214
- Page 1 It is prohibited to copy and make any changes in this manual, without explicit agreement of company COMET SYSTEM, Ltd. All rights reserved. COMET SYSTEM, Ltd. makes constant development and improvement of their products. Manufacturer reserves the right to make technical changes to the device without previous notice.
- Page 2 0.5 m, otherwise undesirable induction of interference signals can appear. Outside diameter of the cable for T2214 device must be from 3,5 to 8 mm (e.g. SYKFY), for device T2214L with respect to the female connector. Do NOT connect shielding at connector side.
- Page 3 This value is then automatically added to measured pressure value. The resultant value of pressure with added correction for altitude must be between 300 hPa and 1350 hPa (from 4.351 PSI to 19.580 PSI). Outside this range device sends value of Error 2! Dimensions – T2214 Connection: Dimensions – T2214L...
- Page 4 ±0.15 ±2.0 ±0.03 ±1.5 ±0.06 ±0.8 ±0.5 ±0.20 Else Response time : t90 <44s There is possible to change response time. For more details see file “Description of calibration and adjustment procedure.pdf”, which is installed together with Users software. IE-SNC-T2214-04...
- Page 5 • Run installed TSensor program and select corresponding communication COM port (as described above). • When new setting is saved and finished, disconnect the cable from the device, connect leads into its terminals and place the lid back to the device. IE-SNC-T2214-04...
- Page 6 It is a serious error, contact distributor of the device. End of operation Device itself (after its life) is necessary to liquidate ecologically! Technical support and service Technical support and service is provided by distributor. For contact see warranty certificate. Appendix A IE-SNC-T2214-04...
Need help?
Do you have a question about the T2214 and is the answer not in the manual?
Questions and answers