Table of Contents
Advertisement
Quick Links
Programmable atmospheric pressure transmitter
© Copyright: COMET SYSTEM, Ltd.
It is prohibited to copy and make any changes in this manual, without explicit agreement
of company COMET SYSTEM, Ltd. All rights reserved.
COMET SYSTEM, Ltd. makes constant development and improvement of their products.
Manufacturer reserves the right to make technical changes to the device without previous notice.
Misprints reserved.
Manufacturer is not responsible for damages caused by using the device in conflict with this
manual.
To damages caused by using the device in conflict with this manual cannot be provide free repairs
during the warranty period.
Read carefully instruction manual before the first device connection.
Contact address of this device's producer:
T2114
with 4-20 mA output
Instruction Manual
COMET SYSTEM, s.r.o.
Bezrucova 2901
756 61 Roznov pod Radhostem
Czech Republic
www.cometsystem.com
Advertisement
Table of Contents
Related Manuals for Comet System T2114
Summary of Contents for Comet System T2114
- Page 1 It is prohibited to copy and make any changes in this manual, without explicit agreement of company COMET SYSTEM, Ltd. All rights reserved. COMET SYSTEM, Ltd. makes constant development and improvement of their products. Manufacturer reserves the right to make technical changes to the device without previous notice.
- Page 2 Don’t connect device while power supply voltage is on. Interconnection terminals of T2114 are accessible after unscrewing four screws and removing the lid. Lace the cable through a gland at the case wall. Connect the cable to terminals with respecting the signal polarity (see figure).
- Page 3 0.5 m, otherwise undesirable induction of interference signals can appear. Outside diameter of the cable for T2114 device must be from 3.5 to 8 mm (e.g. SYKFY), for device T2114L with respect to the female connector. Do NOT connect shielding at connector side.
- Page 4 O or kPa, there is shown only value (number) without corresponding pressure unit! symbol 3 near by left display margin Is on if jumper is closed. Technical parameters: Power: 9 to 30 V dc, maximum ripple 0.5 % Measuring parameters: Atmospheric pressure: IE-SNC-T2114-03...
- Page 5 • Connect SP003 communication cable to the PC. Installed USB driver detect connected cable and create virtual COM port inside the PC. There is possible to change response time. For more details see file “Description of calibration and adjustment procedure.pdf”, which is installed together with Users software. IE-SNC-T2114-03...
- Page 6 It is a serious error, contact distributor of the device. End of operation Device itself (after its life) is necessary to liquidate ecologically! Technical support and service Technical support and service is provided by distributor. For contact see warranty certificate IE-SNC-T2114-03...
- Page 7 Appendix A IE-SNC-T2114-03...
Need help?
Do you have a question about the T2114 and is the answer not in the manual?
Questions and answers