YourCraftsman g enerator requires someassembly
andis ready for useafterit hasbeenproperly serviced
withthe recommended oilandfuel.
If you haveany problemswith the assemblyof
your generator,pleasecallthe generatorhelpline
at 1-800-222-3136.
IMPORTANT: Anyattempt t o runtheenginebefore it
hasbeenserviced withtherecommended oilwillresult
inanengine failure.
TO REMOVE THE GENERATOR
FROM CARTON
•
Set the carton on a rigid flat surface with "THIS
SIDE UP" arrows pointing upward. See "Cold
Weather Operation" on page 9 before cutting
carton.
•
Carefully open the top flaps of the shipping carton.
•
Cut down corners at one end of carton from top to
bottom and lay that side of carton down flat.
•
Remove all packing material, carton filters, etc.
•
Remove the generator from the shipping carton.
CARTON
CONTENTS
Check all contents. If any parts are missing or
damaged, call the generator helpline at
1-800-222-3136.
The carton contains:
•
The main unit
•
Battery charge cables
•
Spark plug
•
Air filter
•
Spark plug wrench
•
Owner's manual
•
Engine oil
•
Wheel kit
ASSEMBLING
THE WHEEL
KIT
The wheel kit is designed to improve the portability of
your generator.
To install the wheel kit, you need the following tools:
•
15/16" box, open end or socket wrench.
•
(2) 13mm box, open end or socket wrenches.
Install wheel kit as follows (refer to illustration below):
•
Place the bottom of the generator cradle on a flat,
even surface.
•
Place axle stud through metal tab on cradle frame.
•
Use a 15/16 inch wrench to secure the axle stud to
frame with 5/8-18 jam nut.
•
Install the other axle stud in the same manner.
NOTE: Be sure to install the wheel with raised hub
inboard.
•
Tip unit and install wheel.
•
Retain wheel on axle stud with retaining pin and
flat washer. Install other wheel on remaining axle
shaft in the same manner.
•
Remove the two front nuts and lock washers from
vibration mounting with 13mm wrench. Use these
nuts to retain the mounting leg.
Wheel Kit
NOTE: Fold-down handle not shown
z_
Axle Stud
%..
>
Mounting Leg
Use existing fasteners
to secure mounting leg'
Flat Washer
;/
5/8-18 Lock
Jam Nut
/
/
/
10" Diameter Wheel
/
Retaining
Pin
4