Advertisement
AssEmblY iNsTrUcTiONs
Step 14: Using 13mm socket, completely tighten all fasteners!!
Step 15: Insert spray can divider (Part #19) into provided cut
away on the bottom shelf (Part #23). (Optional)
1a
HArDWArE sPEciFicATiONs
1a x 32 pcs.
1b x 4 pcs.
4 x 4 pcs.
msc4r / msc4bk / msc4bl / msc4TI / msc4sVA / msc4sb
19
23
2 x 72 pcs.
3 x 56 pcs.
9 x 16 pcs.
msc4r, -bk, -bl, -Ti, -sVA, -sb
TrOUblEsHOOTiNG
Troubleshooting points during msc4 series Assembly:
Problem: Drawers appear not to fit, do not slide in accurately
and bump the cart sides.
Solution: The roller bearing slides must be fully engaged into
the mounting slots on all drawers. They could potentially fall
out of position while turning the cart on its lid or back onto
its caster.
check the side of the cart to determine which slide is out
of position.
remove the drawer that is out of position. The drawer is
removed by the two clips on the actual roller bearing slide.
simply push the roller bearing slide back down into position.
Insert the drawer back onto the roller bearing slides.
Problem: back lock/Unlock switch does not engage
the drawer.
Solution: The inside lock/Unlock slide could potentially fall
out of its groove while turning the cart on its lid or back onto
its casters.
Unscrew the four screws that are holding the lock/Unlock slide
in place.
Once the screws are removed, simply place the latch back onto
the slide and tighten the four screws back down.
Mounting
4
Deluxe service cart
Slots
rev. 10/17/14
Advertisement
