Table of Contents
Advertisement
Cables
3
2
1
Shield
Cable Type: 22AWG Stranded, 2-Pair Twisted-wire, with Shield
Connector Type: 3-Pin XLR Audio (Neutrik or Switchcraft)
Pin 1: Common
Pin 2:
Pin 3: Channel Audio / Power
Shield
4
3
6
5
1
Shield
Cable Type: 22AWG Stranded, 3-Pair Twisted-wire, with Shield
Connector Type: 6-Pin XLR Audio (Neutrik only, not compatible with 6-pin Switchcraft)
Pin 1: Channel 1 & 2 Common
Pin 2: No connection
Pin 3: Channel 1 Audio / Power
Pin 4: Channel 1 Audio / Power
Pin 5: Channel 2 Audio / Power
Pin 6: Channel 2 Audio / Power
Shield
Ch1
Case
Ch2
Shield
*
Standard cables are generally constructed using a male connector at one end and a
female connector at the other end. This allows several cables to be interconnected to
create longer cable runs.
also typically provide both a male and female Neutrik connector for each intercom
channel. This permits loop-through connection of several intercom stations using the
standard cables.
each channel. Audiocom wallplates use male Neutrik connectors.
Audiocom Intercom cable wiring diagrams
FIGURE 14.
TYPICAL 1-CHANNEL CABLE WIRING
Pair 1
Pair 2
Channel Audio / Power
: Earth ground
TYPICAL 2-CHANNEL CABLE WIRING
Pair 1
Pair 2
Pair 3
: Earth ground
3
"Y" CABLE WIRING
2
1
3
2
1
Use second drain wire if available, or add an extra section of wire.
Audiocom master stations, speaker stations and belt packs
Audiocom power supplies use a 3-pin male Neutrik connector for
3
2
1 (Both wires)
Shield
*
Denotes twisted pair.
Denotes shield.
4
3
6
5
1 (Both wires)
Shield
Denotes twisted pair.
Denotes shield.
4
Pair 1
3
6
Pair 2
5
1 (Both wires)
Pair 3
Shield
*
21
Advertisement
Table of Contents
