Craftsman CMHT77639 User Manual page 8

8.
E
Press to measure the distance.
9.
On the bottom line of the screen, view the height
of the building or object.
Distances to 3 Points
You can use the distance to three points on a tall object
to determine its height (Figure
1.
Point the tool's laser (Figure
or object, and not toward anyone's eyes.
2.
Press (Figure
display the red laser dot.
3. FUNCT.
Press four times to show
UNITS
window (Figure
4.
Position the tool opposite the approximate center
of the vertical height to be measured (Figure
).
2
5.
Aim the laser at the highest point of the building or
object (Figure
6.
Press to measure the distance.
7.
From the same point, aim the laser straight
ahead toward the center of the building or object
(Figure ).
J 3
8.
Press to measure the distance.
9.
From the same point, aim the laser at the lowest
point of the building or object (Figure
10.
Press to measure the distance.
11.
On the bottom line of the screen, view the height
of the building or object.
Changing the Unit of Measure
Once the current measurement is taken (the device is
not in Continuous Measure mode), you can change the
unit of measure from fractional inches (7'04
decimal inches (88.8 in), decimal inches to feet (7.40
ft), or feet to meters (2.257 m).
FUNCT.
Press and hold
UNITS
change (2-3 seconds).
8
).
J 1
) toward a wall
A 1
) to turn the tool on and
A 3
on the display
).
F 4
).
J 2
J 4
until you see the measurement
Turning Off the Tool
The tool can be turned off in either of these ways:
• Press and hold
display window clears).
• If you do not use the tool for 120 seconds, it will
automatically turn off.
Limited Warranty
Go to www.CRAFTSMAN.com for the latest warranty
information.
J
).
") to
7/8
for several seconds (until the