Mounting Using Screws - SonicWALL APL66 106 Reference Manual

1.25 inches (31.75 mm). When mounting on drywall, anchors should be used. Anchors must accommodate the
screws and be rated to hold at least 10 lbs (4.5 kg).
The underside of the SonicWave 681 has two insertion points where you can hang the SonicWave by two plastic
insertion stubs located on the underside of the ceiling bracket. You can use these insertion stubs to attach the
bracket to the SonicWave 681 after the bracket has been installed on a ceiling or wall.

Mounting Using Screws

To mount the SonicWave 681 using screws:
1. Measure the distance between the two screw attachment points on the underside of the SonicWave
ceiling bracket.
2. On the mounting surface, mark the locations for the two screw insertion points.
3. Drill pilot holes at the marked locations. For a wood surface, use a drill bit that is appropriate for the
screws. For drywall, use a drill bit that is appropriate for the anchors.
4. For drywall, screw in the anchors.
5. Insert the screws into the wall or anchors, and screw them in deep enough to leave minimal space
between the screw heads and the wall surface.
6. Supporting the SonicWave in your hands, securely fit the underside slots of the SonicWave onto the screw
heads.
SonicWave 681 Safety and Regulatory Reference Guide
SonicWall® SonicWave 681 Safety and Regulatory Information Guide
9