CTC Union CLATRONIC BQ 3507 Instruction Manual page 33

NOTE:
The thermostat is equipped with a safety switch. It prevents
operation of the heating element outside the housing.
Check that the thermostat is properly fitted in the housing.
Electric Installation
1. Be sure the voltage of the device (rating plate) is in
accordance with the mains voltage.
2. Connect the mains plug to a properly installed shockproof
socket only.
Connected Load
The device is intended for a maximum power intake of
2000 W. This connected load recommends a separate input
lead secured with a 16 amp protected switch.
CAUTION: Overload!
• When using extension cords, these should have a cable
cross-section of at least 1.5 mm².
• Do not use gang plugs, because the device is too
powerful.
Prior First-Time Operation
Operate the device without barbecue for 15 minutes whilst
grill pan is filled with water.
Turn the temperature control on the thermostat to the highest
position.
NOTE:
The protective foil on the heating element will be removed.
Slight formation of smoke is thereby normal. Ensure
sufficient ventilation.
Your appliance is now ready for use.
WARNING:
• Always unplug the device and allow the device to cool down
before cleaning.
• Do not under any circumstances immerse the heating element
into water for cleaning. Danger of electric shock or fire.
CAUTION:
• Do not use a wire brush or other scratching objects.
• Do not use acrid or abrasive cleaning agents.
1. Remove the grid, the heating element and windshield.
Pour out the water from the grill pan.
BQ3507_IM_new
Operating the Device
CAUTION:
The appliance must always rest on a horizontal, stable, and
heat resistant surface during use.
1. Pour 1 litre of cold water into the grill pan up to the "MAX"
mark.
2. Preheat the operable device for about 5 minutes prior use.
3. Set the temperature control according to the intended use:
Low or middle settings for keeping warm or cooking,
highest setting for fast cooking or barbecuing. The indica-
tor light indicates the operation of the heating.
4. Place your grill items directly on the grid. Turn the barbe-
cue from time to time.
CAUTION:
• Check the water level! After grilling for a long period, the
water must be replenished.
• First disconnect from the mains and then fill with water
up to the "MAX" mark.
• Do not pour cold water over the hot heating element. It
might get damaged.
End of Operation
Turn the temperature control anti-clockwise as far as it will go
and unplug the device.
The thermostat is equipped with a safety switch. It prevents
operation of the heating element outside the housing.
If the heater cannot be switched on, check the mains outlet
and that the thermostat has been correctly fitted into the
housing.
Cleaning
2. Clean the grid, grill pan, housing and windshield by hand
in a bowl of hot water. Use a nylon brush to remove heavy
stains.
3. Wipe the heating element with a damp cloth.
4. Attach all parts again.
Troubleshooting
17.10.16
33