Philips EVNIA 34M2C8600/75 User Manual page 15

SmartImage Game Mode Ambiglow
OSD Setting USB-C Setting
PIP/ PBP USB Standby Mode
Smart Size KVM
USB Setting
Smart Power
Over Scan
Resolution Refresh Rate
3440X1440 60Hz
Use DP and HDMI as input then use
USB-B/USB-C as USB upstream.
Please follow the steps for the settings.
1. Connect the USB upstream cable
from your dual devices to the "USB
C" and "USB UP" port of this monitor
at the same time.
PC1: USB UP as upstream and HDMI or DP
cable for both video and audio transfer.
PC2: USB-C as upstream (USB C-A) and DP
or HDMI for both video and audio transfer.
Source
HDMI or DP
DP or HDMI
2. Connect peripherals to the USB
downstream port of this monitor.
1
HDMI 1 HDMI 2
USB UP
PC1
3. Enter to OSD menu. Go to KVM
layer and select "Auto", "USB C"
or "USB Up" to switch the control
of peripherals from one device to
another. Simply repeat this step for
switching the control system using
one set of peripheral.
Input Audio System Setup
High Resolution Auto
Off USB C
Auto USB Up
Input Source Adaptive Sync SmartImage
HDMI 1 Off Standard
USB Upstream
USB UP
USB C
PC1/PC2
USBC
PC2
2
USB USB
Close SmartImage Game Mode
OSD Setting
PIP/ PBP
Select Smart Size
USB Setting
OK
Smart Power
Over Scan
Back
Resolution
3440X1440
Note
You can also adopt "MultiClient
Integrated KVM" in PBP mode, when
you enable PBP, you can see two
different sources projected to this
monitor side by side simultaneously.
"MultiClient Integrated KVM" enhances
your operation by using one set of
peripherals to control between in two
systems through the OSD menu setting.
Follow step3 as mentioned above.
1
13
Ambiglow Input Audio System
USB-C Setting High Resolution
USB Standby Mode Off
KVM Auto
Refresh Rate Input Source Adaptive Sync
60Hz HDMI 1 Off
Setup Close
Auto
USB C
USB Up Select
OK
Back
SmartImage
Standard