Table of Contents
Advertisement
A reminder message that pops up after 4 hours
of continuous use, and will then appear every 2
hours after.
To maintain the panel quality, Pixel Refresh will automatically
run after in use for a periods of time.
Pixel Refresh will take few minutes and Power LED will blink until
it is �nished.
Please do not unplug the power cable during the process.
Accumulative usage: 4HOURS
Do you want to activate Pixel Refresh now?
Yes
Compulsory execution message
To maintain the panel's quality, Pixel Refresh will automatically run after
the monitor is in use for 16 continuous hours. This message serves as an
advisory that Pixel Refresh will begin in 10 minutes. It is important to note
that Pixel Refresh is mandatory for proper care of your panel and cannot
be skipped. While in process,Pixel Refresh will be indicated by a
blinking LED indicator until �nished. It is recommended that you do not
unplug the power cable during the process.
Panel Refresh:
After a cumulative usage of 2000 hours,
Panel Refresh will automatically run
and adjust the uniformity of QD OLED
to prevent image retention caused by
static content. When it is activated, the
screen will go into Standby mode for
approximately 1 hour while it finishes
the process. It is important to note that
you cannot skip Panel Refresh process
and when the Panel Refresh has finished,
the LED indicator will stop blinking.
When it is apparent that the Panel
Refresh has finished, turn the monitor
back on and resume activity.
Compulsory execution message
To reduce the risk of image retention, Panel Refresh will automatically run after in use
for a long periods of time.
Panel Refresh will take around an hour and Power LED will blink until it is �nished.
While in process, Panel Refresh will be indicated by a blinking LED indicator until
�nished.
It is recommended that you do not unplug the power cable during the process.
No
• Auto Warning
Default setting is On to provide
messages as reminders of Pixel Refresh
automatically. You can go to OSD menu
> Setup > OLED Panel Care > Auto
Warning to turn off Auto Warning
messages. If you turn off Auto Warning,
the messages will
calculation of cumulative usage hours
continues. If Auto Warning is set to
Off, the cumulative usage exceeds 16
hours, Pixel Refresh will be activated
automatically when you press the power
button or the monitor goes into Standby
mode.
A reminder message that pops up after 4 hours
of continuous use, and will then appear every 2
hours after.
To maintain the panel quality, Pixel Refresh will automatically
run after in use for a periods of time.
Pixel Refresh will take few minutes and Power LED will blink until
it is �nished.
Please do not unplug the power cable during the process.
Accumulative usage: 4HOURS
Do you want to activate Pixel Refresh now?
Note
1. When the monitor is in standby
mode for over two hours, Refresh will
recognize this and run automatically.
Also, if the user turns off the monitor,
Refresh will run automatically.
This ensures your display has
the best possible performance
while minimizing the amount of
interruptions.
2. Please note that if the temperature
inside the monitor's shell reaches
a temperature of over 45 degrees
Celsius, Pixel Refresh nor Panel Refresh
can be activated.
24
not appear, yet the
Yes
No
Advertisement
Table of Contents
