PERIODIC MAINTENANCE AND MINOR REPAIR
1. Coolant reservoir
2. Maximum level mark
3. Minimum level mark
3. Check the coolant level in the
coolant reservoir.
NOTE:
@
The coolant should be between the
7
minimum and maximum level marks.
@
1. Coolant reservoir cap
4. If the coolant is at or below the
minimum level mark, remove the
rider seat (See page 3-13 for rider
seat removal and installation pro-
cedures.), open the reservoir cap,
add coolant to the maximum level
mark, and then close the reservoir
cap and install the rider seat.
Coolant reservoir capacity:
0.89 US qt (0.74 Imp qt, 0.84 L)
7-17
CAUTION:
@
G
If coolant is not available, use
distilled water or soft tap water
instead. Do not use hard water
or salt water since it is harmful
to the engine.
G
If water has been used instead
of coolant, replace it with cool-
ant as soon as possible, other-
wise the engine may not be
sufficiently cooled and the cool-
ing system will not be protected
against frost and corrosion.
G
If water has been added to the
coolant, have a Yamaha dealer
check the antifreeze content of
the coolant as soon as possible,
otherwise the effectiveness of
the coolant will be reduced.
@
WARNING
@
Never attempt to remove the radia-
tor cap when the engine is hot.
@
5. Install the panel.
EC000080
EW000067