Table of Contents
Advertisement
Table 20. Expansion card slots supported on the system board (continued)
PCIe slot
Risers
Slot 2
N/A
(Gen4)
Slot 3
N/A
(Gen3)
Slot 4
N/A
(Gen3)
NOTE:
Slot 1 is disabled, when system is installed with Intel Pentium processor.
NOTE:
The expansion-card slots are not hot-swappable.
The following table provides guidelines for installing expansion cards to ensure proper cooling and mechanical fit. The expansion
cards with the highest priority should be installed first using the slot priority indicated. All the other expansion cards should be
installed in the card priority and slot priority order.
Table 21. Configuration : No Riser
Card type
Foxconn (APERC 11)
Foxconn (APERC HBA11)
Foxconn (external adapter)
Foxconn (APERC 10.15)
Broadcom (NIC: 1Gb)
Intel (NIC: 1Gb)
BOSS S2 Module
Removing an expansion card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. If required,
remove the air
4. Disconnect any cables that are connected to the expansion card.
Steps
1. Loosen the captive screw and tilt the metal bracket that holds the expansion cards.
2. Hold the expansion card by the edges, and pull the card up to remove it from the expansion card connector on the system
board.
68
Installing and removing system components
Processor
connection
Processor 1
Platform Controller
Hub
Platform Controller
Hub
Slot priority
2
2, 1
2, 1
2
2, 1, 4
2, 1, 4
Integrated slot
Safety
instructions.
Before working inside your
shroud.
PCIe slot height
PCIe slot length
Full height
Full height
Full height
system.
PCIe slot width
Full length
Half length
Half length
x4 link in x8 slot
Maximum number of cards
1
2
2
1
3
3
1
x16
x1
Advertisement
Table of Contents
