c) Prevent unintentional starting. Ensure the GENERAL POWER TOOL SAFETY switch is in the off -position before connecting WARNINGS to power source and/or battery pack, picking up or carrying the tool. WARNING Carrying power tools with your fi nger on the switch Read all safety warnings, instructions, illustrations and or energising power tools that have the switch on specifi...
Slippery handles and grasping surfaces do not Safety instructions when using long drill bits with allow for safe handling and control of the tool in rotary hammers unexpected situations. 4. Always start drilling at low speed and with the bit tip in contact with the workpiece.
17. Rotation + hammering 2. Do not pierce battery with a sharp object such as a When the drill bit touches construction iron bar, the bit nail, strike with a hammer, step on, throw or subject the will stop immediately and the rotary hammer will react battery to severe physical shock.
Page 11
Dust box latch Auto stop lamp: Lights Power Output Battery sliding Filter grooves Adapter Terminal (Product) 2 to 3 digit number Latch Air gun Charge indicator lamp Terminal (Battery) Indicator lamp: Lights Sliding grooves USB DEVICE CONNECTION Grease Rubber cover PRECAUTIONS (UC18YSL3) Pushing button USB port...
BSL18xx and BSL14xx series) cannot be used with this * Depending on attached battery. The heaviest weight is tool. measured with BSL36B18 (sold separately). ○ Due to HiKOKI’s continuing program of research and development, the specifi cations herein are subject to Battery change without prior notice.
Page 13
Table 1 Indications of the charge indicator lamp Lights for 0.5 seconds. Does not light for Before Blinks 0.5 seconds. (off for 0.5 seconds) Plugged into power source charging (RED) Lights for 0.5 seconds. Does not light for Blinks 1 second. (off for 1 second) Battery capacity at less than 50% (BLUE) Lights for 1 second.
4. Disconnect the charger’s power cord from the Installing / Removing the side receptacle. handle 5. Hold the charger fi rmly and pull out the battery. NOTE Inserting SDS-plus drilling tools Be sure to pull out the battery from the charger after use, Removing SDS-plus drilling tools and then keep it.
CAUTION ABOUT THE PROTECTION ○ Switch ON the tool once you place the tip of the tool on FUNCTION the work material. ○ The rotation speed and the level at which the switch is This tool has a built-in protection circuit for preventing pulled during drilling is not stored to memory.
MAINTENANCE AND INSPECTION Important notice on the batteries for the HiKOKI cordless power tools WARNING Please always use one of our designated genuine Be sure to turned off the switch and remove the battery batteries. We cannot guarantee the safety and before maintenance and inspection.
TROUBLESHOOTING Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your dealer or the HiKOKI Authorized Service Center. 1. Power tool Symptom Possible cause Remedy Tool doesn’t run No remaining battery power Charge the battery.
Page 18
Symptom Possible cause Remedy Charging of the USB device The battery has become fully charged. This is not a malfunction. pauses midway when the The charger pauses USB charging for battery and the USB device about 5 seconds while it checks whether are being charged at the the battery has successfully completed same time.
Page 19
DH36DPE DH36DPE 36 V 0–950 min 0–4300 min 28 mm 20 mm φ max 13 mm – φ max 32 mm – φ max 3.6–3.9 kg 4.7–5.0 kg BSL36A18 UC18YSL3 DH36DPE 2XCS – – – – – – –...
Page 23
English Dansk Română GUARANTEE CERTIFICATE GARANTIBEVIS CERTIFICAT DE GARANŢIE Model No. Modelnummer Model nr. Serial No. Serienummer Nr. de serie Date of Purchase Købsdato Data cumpărării Customer Name and Address Kundes navn og adresse Numele și adresa clientului Dealer Name and Address Forhandlers navn og adresse Numele și adresa distribuitorului (Please stamp dealer name and address)
Page 25
Tel: +32 2 460 1720 URL: http://www.hikoki-powertools.hu Fax: +32 2 460 2542 URL http://www.hikoki-powertools.be Hikoki Power Tools Polska Sp. z o. o. ul. Gierdziejewskiego 1 Hikoki Power Tools Italia S.p.A 02-495 Warszawa, Poland Via Piave 35, 36077, Altavilla Vicentina (VI), Italy...
Page 27
EN62841-2-6:2020+A11:2020 EN60335-1:2012+A11:2014 EN60335-2-29:2004+A2:2010 EN55014-1:2006+A1:2009+A2:2011 EN55014-2:1997+A1:2001+A2:2008 Representative offi ce in Europe 31. 1. 2023 Hikoki Power Tools Deutschland GmbH Akihisa Yahagi European Standard Manager Siemensring 34, 47877 Willich, Germany 31. 1. 2023 Head offi ce in Japan Koki Holdings Co., Ltd.
Page 28
EN IEC 62841-2-6:2020+A11:2020 EN60335-1:2012+A11:2014 EN60335-2-29:2004+A2:2010 EN55014-1:2006+A1:2009+A2:2011 EN55014-2:1997+A1:2001+A2:2008 Importer and authorized person to compile the technical file Hikoki Power Tools (U.K.) Ltd. 25 Majestic Road, Southampton, SO16 OYT, United Kingdom 31. 1. 2023 Head office in Japan Koki Holdings Co., Ltd.
Need help?
Do you have a question about the DH 36DPE and is the answer not in the manual?
Questions and answers