Vaporesso GEN PT60 - Vape Kit Manual
Also See for GEN PT60:

Advertisement

Vaporesso GEN PT60 - Vape Kit Manual

ENLARGED VIEW

Thank you for choosing Vaporesso product. Please read this instruction carefully before use to ensure a perfect experience.
If there is any additional requirement about this product, please consult the local agent or contact us through our website: www.vaporesso.com

ENLARGED VIEW

SPECIFICATION

Dimensions: 112 x 35 x 28 mm
POD Capacity: 4.5ml/2ml(TPD)
Coils & Suggested Wattage: GTX 0.2Ω MESH Coil (45-60W); GTX 0.4Ω MESH Coil (26-32W)
Battery Capacity: 2500mAh
Output Power: 5-60W
Charging Current: DC 5V/2A,Type-C
Battery Display: 0.91'' OLED Screen

PACKING LIST

1 x VAPORESSO GEN PT60 Battery
1 x VAPORESSO xTANK POD (4.5ml/2ml TPD)
1 x GTX 0.2Ω MESH Coil (In-box)
1 x GTX 0.4Ω MESH Coil (In-box)
1 x Type-C Cable
1 x User Manual
1 x Warranty Card

USE INSTRUCATIONS

  1. Install the POD
    Install the POD onto the battery at the correct place. Make sure they are firmly connected.
    *Refer to the figure 1 above.
    Install the POD
  2. Replace the Coil
    • Take out the POD from the battery;
    • Pull out the used coil from the POD;- Install a new coil to the POD;
    • Reattach the POD into place.
    • Refer to the figure: 2 above.
      Replace the Coil
  3. Fill E-liquid
    • Twist the top cap according to the arrow direction until the refilling port show out;
    • Pull out the silicone plug and fill e-liquid through the hole, then twist the top cap in place after filling is finished. - Please wait 5 minutes for the e-liquid to soak into the coil completely.
      *Refer to the figure 3 above.
      Fill E-liquid
  4. Adjust the Airflow
    To adjust the airflow volume, please rotate the top cap on the POD.
  5. Power on the Device
    Click the power button 5 times in 2 seconds to power on or power off the device.
  6. Power Adjustment
    GEN PT60 is using the powerful GTX coil platform, and the suggested power need to be noticed before start vaping.
    GTX MESH Coils GTX 0.2Ω MESH GTX 0.4Ω MESH
    Suggested Power 45-60W 26-32W
  7. Start Vaping
    Press the power button to enjoy extraordinary vaping experience.
  8. Charge the Battery
    After connecting the Type-C cable to the battery, the battery indicator and remaining charging time will be showed on the screen.
  9. Settings
    SYSTEM LOCK/UNLOCK: Press power button 3 times. PUFF: To clear the puff counter, please press power button and "-" button;
    Flip Screen: To flip the screen direction, please press power button and "+" button.
    Press "+"and "–" buttons together to enter the setting interface.
    VW: Wattage adjustment mode;
    VV: Voltage adjustment mode;
    SMART VW: The power of device will be adjusted automatically according to the coils; DEFAULT: Restore factory settings; EXIT: Back to main interface.

PROTECTIONS

Protections Situation
USB Input Protection The USB input voltage is too high.
Low Battery Protection The battery drops too low.
No Load Protection The device detects no cartridge on the battery.
Short-circuit Protection The device detects a short circuit.
Overtime Protection Constantly vape for more than 10 seconds.
Overheat Protection The device detects an overheated PCBA.

CAUTIONS

  • Please turn off the device when it is not in use.
  • Do not leave the charging device unattended.
  • Do not drop, throw or abuse your device, which may cause damage.
  • Please use a standard USB output charger with proper charging current and voltage range.
  • Keep away from the water or any flammable gas, liquid.
  • Do not expose the device to direct sunlight, dust, moisture or mechanical shock.
  • Do not expose the device to extreme temperature. (Recommended temperature range: -10~60 ℃ /14~140 ℉ while using and -10~45℃ /14~113℉ while storing).
  • EEE Recycling: the product should not be treated as household waste, instead, it should be handed over to the applicable collection point for the recycling of electrical and electronic equipment.
  • Battery Recycling: the product battery should not be treated as household waste, instead, it should be handed over to the applicable used battery collection point for recycling.
  • Only have your device repaired by Vaporesso. Do not attempt to repair it by yourself as damage or personal injury may occur.

WARNING

This refillable electronic cigarette is intended for use with compatible e-liquid, which may contain nicotine. Nicotine is an addictive substance and it is not suitable or recommended to use in following cases:

  1. This device is not suitable for:
    • Persons under the legal smoking age.
    • Persons experiencing heart disease, stomach or duodenal ulcers, liver or kidney problems, long-term throat disease or difficult breathing due to bronchitis, emphysema or asthma. - Persons with an overactive thyroid gland or experiencing phaeochromocytoma (a tumour of the adrenal gland that can affect blood pressure).
    • Persons taking certain medications like Theophylline, Ropinirole or Clozapine and etc..
  2. This device is not recommended for
    • Non-smokers
    • Pregnant or breastfeeding women
  3. You may experience the following results if you use nicotine containing e-liquid with this product. If it happens, please consult a healthcare professional and show them this leaflet if possible:
    Feeling faint/Nausea /Dizziness/Headache /Coughing/ Irritation of the mouth or throat/Stomach discomfort/ Hiccups/Nasal congestion/Vomition/Chest palpitations/pain or an irregular heart rate

This device should not be used by persons under the legal smoking age.

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Vaporesso GEN PT60 - Vape Kit Manual

Advertisement

Need Assistance?

Do you have a question about the GEN PT60 that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents