EDIFIER X2s - True Wireless Earbuds Headphones Manual

1. Power ON when taken out of the case.
2. Power OFF when placed in the case.

Note:
If there is no Bluetooth connection for 10 minutes after powered on, the earbuds will power off automatically.

Pairing

1st Pairing

1. Taken out of the case. White and blue LEDs will blink alternately.
2. Select "EDIFIER X2s" in your Bluetooth device setting to connect. White LED will blink twice in 5 seconds when successfully.

Note:
For subsequent use, the earbuds will automatically connect to the device used last time.

1. Taken out of the case.
2. Disconnected from any Bluetooth device. Press and hold the touch panel on either earbud for around 8s until blue LED blinks 6 times to clear the Bluetooth pairing records and power off. If the left and right earbuds are connected, the other side will clear the Bluetooth pairing record and power off too.
3. Placed back in the case and taken out of the case again.
4. Select "EDIFIER X2s" in your Bluetooth device setting to connect. White LED will blink twice in 5 seconds when successfully.

1. When earbuds are powered on and there is no Bluetooth connection and TWS connection, respectively tap the touch panel 5 times on both earbuds until white LED blinks slowly to enter TWS pairing mode. Once the left and right earbuds are connected successfully, white and blue LEDs will blink alternately to enter Bluetooth pairing mode.
2. Select "EDIFIER X2s" in your Bluetooth device setting to connect. White LED will blink twice in 5 seconds when successfully.

Earbuds

1. When hearing a low battery prompt tone, please place the earbuds in the case for charging.
2. White LED on earbud is steady lit when charging and off when fully charged.

Charging Case

1. Please connect the case to power source with the included Type-C charging cable for charging.
2. White LED is steady lit when charging and off when fully charged.

Note:
Please do not charge the earbuds when there is sweat or other liquids inside the charging port, which may damage the earbuds.

Input:
5V ~200mA(Earbuds)
5V~1A(Charging case) Indicator

Note:

1. Images are for illustrative purposes only and may differ from the actual product.
2. Download Edifier Connect App for more customizable control settings.

For more information, please visit our website:

www.edifier.com

@Edifierglobal

@Edifier_Global

@Edifier_Global

Model: EDF200123
Edifier International Limited
P.O. Box 6264
General Post Office
Hong Kong

www.edifier.com
2023 Edifier International Limited. All rights reserved. Printed in China

NOTICE:
For the need of technical improvement and system upgrade, information contained herein may be subject to change from time to time without prior notice.

Products of EDIFIER will be customized for different applications. Pictures and illustrations shown on this manual may be slightly different from actual product. If any difference is found, the actual product prevails.