Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Tascam CD-BT1
Summary of Contents for Tascam CD-BT1
- Page 1 » CD-BT1 Portable CD Bass Trainer OWNERʼS MANUAL is appliance has a serial number located on the rear panel lease record the model number and serial number and retain them for your records odel number _____________ erial number _____________...
- Page 2 WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. — TASCAM CD-BT1 FOR U.S.A. TO THE USER This equipment has been tested and found to comply with the limits for a Class B digital de- vice, pursuant to Part 15 of the FCC Rules.
-
Page 3: Important Safety Instructions
Do not install this apparatus in a confined space such as a book case or similar unit. • The apparatus draws nominal non-operating power from the AC outlet with its POWER switch in the off position. Important Safety Instructions TASCAM CD-BT1 —... - Page 4 TACT YOUR NEAREST QUALIFIED SERVICE PERSONNEL, AND DO NOT USE THE PROD- UCT IN ITS DAMAGED STATE. Optical pickup: Type KSM-900AAA Manufacturer: SONY CORPORATION Laser output: <1 mW play on the objec- tive lens Wavelength: 775—816 nm — TASCAM CD-BT1...
-
Page 5: Table Of Contents
Table of contents First steps with your CD-BT1...6 Making connections ...8 Using the menu system ...10 Using the CD player...12 Pitch and tempo changes ...14 Using effects...15 Effect presets and parameters ...16 EQ setting...17 Using the tuner...18 Facts and figures (specifications) ...19... -
Page 6: First Steps With Your Cd-Bt1
First steps with your CD-BT1 About this manual hen we refer to a key or connector or control on the we write it like this PLAY hen we refer to an item shown on the display we write it like this... - Page 7 BASS IN jack and effect unit f this section is off you cannot use this jack or use any of the instru First steps with your CD-BT1 mentrelated menu systems effect and tuner lso note the HOLD switch that locks the s controls and keys when...
-
Page 8: Making Connections
You should NEVER connect the speaker out- puts of a bass or guitar amplifier to anything except speakers. If you are in any doubt at all about what you can connect to your CD-BT1, ask someone who knows. Connecting a footswitch ou can connect a footswitch to the... - Page 9 ��������������� ������������� ���������������� ��������������� ������������������ ��������������������� ������������������ ����������������������� ���������������� ��������������� �������������� Outputs ere are two outputs the line and the headphones ese cannot have their levels set separately—use the OUTPUT control to set the overall output level TASCAM CD-BT1 —...
-
Page 10: Using The Menu System
NOTE The TUNER menu requires you to press ENTER after the TUNER menu is shown on screen (as the effect sound is cut when the tuner is operational). — TASCAM CD-BT1 Menu Menu item Values ON/OFF 00 to 15 Parameter(s) —... - Page 11 Depending on the effect chosen, there may be more than one MIX setting available, as well as a different number of individual effects Using the menu system Automatic or manual tuning calibration in Hz TASCAM CD-BT1 —...
-
Page 12: Using The Cd Player
marked PULL NOTE The CD-BT1 cannot play unfinalized CD-R/ RW discs. In addition, some finalized CD-R/ RW discs may be unplayable on the CD-BT1. Playback ress the playpause key to Á/π start playback and to pause playback... - Page 13 CUT c ing the treble region emember that these settings have no effect on the sound of the bass instru ment plugged into the TASCAM CD-BT1 —...
-
Page 14: Pitch And Tempo Changes
the mode is off if is on this is also off hen this mode is on the display — TASCAM CD-BT1 shows se this mode when you find the key of the track difficult to play... -
Page 15: Using Effects
you should also make sure that the effect is switched on If you have a footswitch connected and the FOOT menu item is set to EFF, you can step through the slots by pressing the footswitch. TASCAM CD-BT1 —... -
Page 16: Effect Presets And Parameters
ompressor gain for low frequen CMPL cies horus setting istortion gain DIST elay setting — TASCAM CD-BT1 DLY, MIX2 FLA, MIX1, DLY, MIX2 CHO, MIX1, DLY, MIX2 WAH, MIX1, DLY, MIX2 CMPL, CMPH CMPL, CMPH, DLY, MIX2 CMPL, CMPH, FLA, MIX1, DLY, MIX2... -
Page 17: Eq Setting
e last parameter is the mid shaper displayed as which performs sub tle operations on the midrange of the bass instrument in order to emphasize the bass tones of your playing xit the setting mode by pressing DISPLAY/ESC key TASCAM CD-BT1 —... -
Page 18: Using The Tuner
z and z NOTE Although you do not need to play a CD when you are tuning, the CD-BT1 must be switched on, and the BASS button must be pressed in to allow tuning of the instrument plugged... -
Page 19: Facts And Figures (Specifications)
AA batteries x 4 (NiMH or alkaline) Power consumption 4W (PS-PS5 AC adapter) Dimensions (w x d x h) 232 x 138 x 40 including feet (mm) 9.1 x 5.4 x 1.6 (in) Weight (excluding 620g / 1lb, 6oz batteries) TASCAM CD-BT1 —... - Page 20 17 Rue Alexis-de-Tocqueville CE 005 92182 Antony Cedex FRANCE +33-1-42-37-01-02 TEAC ITALIANA S.p.A. Via C Cantu 11 20092 Cinisello Balsamo Milano ITALY +39-02-66010500 TEAC AUSTRALIA PTY., LTD. 280 William St Melbourne Victoria 3000 AUSTRALIA +61-3-9672-2400 CD-BT1 www.tascam.com www.tascam.com www.tascam.com www.tascam.com www.tascam.co.uk www.tascam.de www.tascam.fr www.teac.it...