Using Effects - Tascam CD-BT1 Owner's Manual

How effects work
ere are five slots numbered from
through where you can store your
1 5
own effect settings
ffects are created from the  preset
effects available hen a slot is se
lected if a preset effect is recalled and
edited that slot is automatically filled
with the edited effect
Storing your own effect settings
in a slot
ress the EFFECT key to select the slot
 through  as shown on the display
1 5
ress and hold the
EFFECT
the LCD MENU key until
pears on the display
or
se the key to turn the effect
6
ress ENTER
preset effect 
and fl keys
6
NOTE
If there were any settings in the selected slot
to start with, they will be overwritten when
you recall a library entry.
key or press
ap
EFFECT ress ENTER
ing the parameters with the the
fl keys see the table for details of these
parameters
e last parameter is always
output level from the effect unit 
 is is only available when the ef
64

ON
 and then select the
through  with the
00 15
once more to start edit
and
6
LVL the
to
0

Using effects

fect is active and is bypassed with the
effect off
et the level and then press the
DISPLAY/ESC key to exit the effect
settings e effect settings you have
made are automatically stored in the
slot you first chose
Recalling an effect with your
settings
hen you have stored the effect set
tings in a slot as described above you
can recall them simply pressing the
EFFECT key to select the appropriate
slot you should also make sure that the
effect is switched on
TIP
If you have a footswitch connected and the
FOOT menu item is set to EFF, you can step
through the slots by pressing the footswitch.
TASCAM CD-BT1 —
15