Targus PA075U User Manual page 4

1 Turn off your computer.
2 (Model PA095 only) Open the USB cable
compartment, located on the bottom of the port
replicator, and uncoil the cable.
3 Connect the supplied AC power adapter to the AC
power jack on the port replicator.
4 Plug the USB connector end of the USB cable into the
USB port of your computer.
5 Turn on your computer.
The following will configure automatically:
• Ethernet 10/100 (Model PA095 only)
• Serial Interface Controller
• USB Device (twice)
• Parallel Interface Controller
• PS/2 Adapter (twice)
This configuration process takes a few minutes. The
operating system does not prompt when configuration is
complete. Watch that all hardware devices are configured
before opening another application or connecting devices
to the port replicator.
NOTE: some hardware devices may prompt you for the
location of device drivers.
To install the drivers:
1 Select "Install the software automatically
(Recommended)" and click Next.
The Found New Hardware Wizard program begins
installing the hardware drivers.
4