Advertisement
•
Place the loosely assembled frame onto the rear of
the b'actor,hooking the notched ends of the mounting
brackets under the shoulder bolts, Attach the hitch
bracket to the tractor hitchusing the clevis pin and a
1/8" hairpin clip. See figure 6.
•
Align the frame so that it is straight and level with the
tractor. Tighten the four 5/16" x 3/4" hex bolts
(assembled in figure 4) which fasten the mounting
brackets to the hitch bracket.
•
Slide the 3/8" x 1" hex boltsalong the hitch bracket
slots untilthey are bumped up against the back edge
of the tractor hitch.Tighten. See figure 6.
•
Place the tool box onto the frame so that the heads
of the shoulder boltsin the bottom of the tool box fit
down intothe keyhole slots. Slide the tool box
forward, slightlytilting up the back end, untilthe
clevis pins in the bottomof the tool box drop down
into the holes at the rear of the frame. Secure the tool
box to the frame with two 1/8" hairpin clips through
the clevis pins. See figure 7.
•
Tighten the two bolts (assembled in figure 5) which
fasten the brace strap to the mountingbrackets. The
strap keeps the frame at the correct alignmentwidth
when removingand reattachingthe frame and the tool
box.
3/8" x 1"
HEXBOLT'-----.
I
I
I
I
t
SHOULDER
BOLT
F
6
[o]"J =1 : ,JIII
&
CAUTION:
Vehicle braking and stability
may be affected with the addition of an
accessory or en attachment. Be aware of
changing conditions on slopes.
•
Engage the tractor clutch smoothly whert starting
the tractor in motion. Sudden, full throttle starts
could cause the front end of the tractor to lift off the
ground, causing loss of steering control.
•
Fill the Trac Pack with up to 100 pounds of material
or tools.
•
Do Not exceed the 100 pound weight capacity of
the Trec Pack.
•
To remove the tool box from the Trac Pack frame,
'remove the 1/8" hairpin clips from the two clevis pin
in the bottom of the tool box. Lift up the rear of the
tool box enough to raise the pins o,t of the frame
end then pull back and up tO remove the heads of
the shoulder bolts from the slots in the frame.
•
To remove the Trac Pack frame from the tractor,
remove the 1/8" hairpin clip end the clevis pin from
the hitch bracket. Unhook the frame from the
shoulder bolts on the sides of the tractor and
remove the frame. The shoulder bolts may be left
permanently attached.
•
Rinse or wipe off the Trac Pack after each use.
•
Do not store with material in the tool box.
•
Store inside in a clean, dry area.
Advertisement
