Andis LS / LS2 - Hair Trimmer Use And Care

IMPORTANT SAFEGUARDS

When using an electrical appliance, basic precautions should always be followed, including the following: Read all instructions before using the Andis Trimmer.

To reduce the risk of electric shock:

1. Do not reach for an appliance that has fallen into water. Unplug immediately.
2. Do not use while bathing or in a shower.
3. Do not place or store appliance where it can fall or be pulled into a tub or sink. Do not place in or drop into water or other liquid.
4. Always unplug this appliance from the electrical outlet immediately after using.
5. Unplug this appliance before cleaning, removing, or assembling parts.

To reduce the risk of burns, fire, electric shock, or injury to persons:

1. An appliance should never be left unattended when plugged in.
2. Close supervision is necessary when this appliance is used by, on or near children or individuals with certain disabilities.
3. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by Andis.
4. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the appliance to an Andis Authorized Service Station for examination or repair.
5. Keep the cord away from heated surfaces.
6. Never drop or insert any object into any opening.
7. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
8. Do not use this appliance with a damaged or broken blade or comb, as injury to the skin may occur.
9. To disconnect turn control to "off" then remove plug from outlet.

SAVE THESE INSTRUCTIONS
THIS PRODUCT INTENDED FOR HOUSEHOLD USE

This appliance has a polarized plug (one blade is wider than the other). As a safety feature, the plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

OPERATING INSTRUCTIONS

Please read the following instructions before using your new Andis Trimmer. Give it the care that a fine precision built instrument deserves and it will give you years of service. Before starting trimmer remove blade guard (some models may not have a blade guard). Plug cord into electrical outlet, operate at 120 volt, 60 cycle AC electrical current or as noted on the unit. To start trimmer move switch button to on position, to stop, move switch button back to original position. After using your Andis Trimmer, rewrap cord and store in a safe place. Some of the "basic" uses for a trimmer are illustrated below:

SHAVES BACK OF NECK

Extra fine blade takes just the right amount of hair... thoroughly shaves neck in seconds.

SHAPES HAIRLINE

Trimmer cuts a sharp hairline. Helps you give a neat, smooth shave right up to the line.

TRIMS AROUND THE EARS

Extra fine blade and narrow head makes shaping and trimming hairline around ears fast and easy.

FINISHES SIDEBURNS

The trimmer's cutting head makes a clean, level, professional line. A few upward strokes shaves hair below line.

USER MAINTENANCE

The internal mechanism of your trimmer has been permanently lubricated at the factory. Other than the recommended maintenance described in this manual, no other maintenance should be performed, except by Andis Company or an Andis Authorized Service Station. To find an Andis Authorized Service Station near you log on to www.andis.com or contact our customer service department: 1-800-558-9441 (U.S.) or 1-800-335-4093 (Canada).

CARE AND SERVICING OF YOUR ANDIS TRIMMER BLADES

Blades should be oiled before, during, and after each use. If your trimmer blades leave streaks or slows down, it's a sure sign blades need oil. The trimmer should be held in a position shown (Diagram B) to prevent oil from getting into motor. Place a few drops of Andis Trimmer Oil on the front and side of the cutter blades (Diagram A). Wipe excess oil off blades with a soft dry cloth.

Spray lubricants contain insufficient oil for good lubrication, but are an excellent trimmer coolant. Always replace broken or nicked blades to prevent injury. You can clean the excess hair from your blades by using a small brush or worn out toothbrush. To clean the blades we suggest to immerse the blades only into a shallow pan of Andis Trimmer Oil, while the trimmer is running. Any excess hair and dirt that has accumulated between the blades should come out. After cleaning, turn your trimmer off and dry blades with a dry cloth and start clipping again.

To remove blade set from your trimmer, unplug your trimmer from the electrical outlet. Turn the trimmer upside down so the teeth of blades are facing down. You may wish to set the trimmer on a flat surface while performing these operations. Using a phillips type screwdriver, unscrew the two blade screws (Diagram C). Remove blade set from trimmer. To install your new trimmer blade set, align hole in upper blade (smaller of the two blades) and center over nylon roller (ball) of the trimmer's tension spring (Diagram D). Align screw holes of lower blade (larger of the two blades) to housing screw holes (Diagram D). While holding blade in place, replace blade screws; do not tighten down completely. Turn trimmer over and align the blade set parallel to the trimmer's upper housing.

Check blade alignment, making sure the teeth of the upper blade rest slightly below the upper edge of teeth on lower blade. Failure to check the position of blade may cause cutting or scratching of your skin when trimming.
Tighten down blade screws firmly.

FACTORY REPAIR SERVICE

When the blades of your Andis clipper/trimmer become dull after repeated use, it is advised to purchase a new set of blades available through your Andis Supplier or through an Andis Authorized Service Station. If you wish your clipper/trimmer to be serviced as well, it should be carefully packed and mailed either Parcel Post Insured, or U.P.S. to any Andis Authorized Service Station.

Andis Company
1800 Renaissance Blvd.
Sturtevant, WI 53177
1-800-558-9441
Canada: 1-800-335-4093 info@andisco.com
www.andis.com