Table of Contents
Advertisement
M3057-PLR Mk II Dome Camera
Specifications
D-coded M12 connector with Power over Ethernet (PoE).
1
TX+
2
RX+
3
TX-
4
RX-
SFP connector.
NOTICE
NO
NO
TICE
TICE
Use the supplied midspan.
NOTICE
NO
NO
TICE
TICE
To comply with the IP66-rated design of the camera and maintain the IP66 protection, the supplied RJ45 Push-pull Connector
(IP66) shall be used. Alternatively, use the RJ45 IP66-rated cable with premounted connector which is available from your
Axis reseller. Do not remove the plastic network connector shield from the camera.
I/O connector
Use the I/O connector with external devices in combination with, for example, motion detection, event triggering, and alarm
notifications. In addition to the 0 V DC reference point and power (12 V DC output), the I/O connector provides the interface to:
Digital input - For connecting devices that can toggle between an open and closed circuit, for example PIR sensors, door/window
contacts, and glass break detectors.
Supervised input - Enables possibility to detect tampering on a digital input.
Digital output - For connecting external devices such as relays and LEDs. Connected devices can be activated by the VAPIX®
Application Programming Interface, through an event or from the device's web interface.
A digital light sensor - For receiving a value of the ambient light intensity from an external light sensor. This is used to control the
device's day and night functionality.
Note
The I/O connector is connected to the housing (fan/heater) on delivery. In case of a fan or heater error, an input signal will be
triggered in the camera. Set up an action rule in the camera to configure which action the signal shall trigger.
4-pin terminal block
6-pin terminal block
56
Advertisement
Table of Contents
