Cleaning, Maintenance And Storage; Travelling With The Device; Troubleshooting; Labels And Symbols - Braun Silk-expert Mini PL1 Manual

9 Cleaning, Maintenance and Storage

After treatment, always unplug the device.
After each treatment, inspect the treatment window (1), the skin tone sensor (2), the glass filter (3) and the
built-in reflector for damage.
Wipe the treatment window with a dry, lint-free cloth if any marks or black spots are visible.
WARNING: The glass filter (3) can get hot during use. DO NOT touch or clean the filter for at least 5 minutes
after use to allow it to cool down.
NEVER use water or other cleaning fluids, as these can damage the device leading to a potential safety hazard.
Store the device in a cool, dry place. Make sure that the treatment window and skin tone sensor is
protected from damage.
Regularly check the device (including cords) for visible signs of damage. In case of damage or cracks,
stop using the device.
  Travelling with the Device
The device will work with all commonly encountered mains supplies. Providing you have a suitable adaptor
for the mains power cord, the device will operate as normal.
  Troubleshooting
Problem
Power indicator (4) does not light up when
treatment window is placed on the skin.
Flashing sequence slows down.
Red light on power indicator
Red flashing power indicator light
Power indicator light flashes alternately red and
white.
The device is broken, cracked or appears
defective.
 Labels and Symbols
The base station is marked with the following symbols:
12
Type BF Applied Part
Class II equipment
Solution
Make sure the device is connected to an electrical
outlet. Press the treatment button to activate it.
Ensure that the entire treatment window area
touches the skin. If needed, move the device to
improve skin contact.
Device is in heat-protection mode. To get back to
normal speed, allow device to cool down.
Invalid skin tone reading. Your skin is either too
dark or too light. For safety reasons, the device will
not flash.
Device error. Device will not operate.
Unplug and re-connect.
If error persists, contact a Braun Service Center.
End of product lifetime. Maximum number of
flashes (300,000) has been reached.
DO NOT USE if the handle, the base station or the
mains cord is damaged.