Table of Contents
Advertisement
CARE FOR YOUR SHAVER
C
C
Care for your shaver to ensure a long lasting performance. We recommend
you clean your shaver after each use.
Ensure your shaver is switched off before cleaning.
1.
Open the shaver head by pressing the release button (Fig. C).
2.
The head assembly will open (Fig. D).
3.
Rinse under a tap to wash away hair trimmings.
4.
Carefully brush away any hairs from the cutters.
5.
Snap the head assembly closed.
Note: The individual cutters are designed to be permanently retained in the
shave head and flushed out with water. Do not remove the individual cutters
for cleaning.
DETAIL TRIMMER
Lubricate the teeth of the detail trimmer every six months with a drop of
sewing machine oil.
REPLACING THE HEAD & CUTTERS
Please refer to the specifications' table on page 5 of this manual that lists
the correct replacement part number for your shaver.
It is very important to replace your head and cutters when necessary to
ensure a close, comfortable shave without irritation. We recommend they
be replaced every 6 months. Here are some signs of head and cutter wear,
indicating that replacement is needed:
Irritation: As the heads get excessively worn you may experience
•
some skin irritation. This would be especially noticeable when you
apply moisturizing lotion.
Pulling: When the cutters wear you may feel a sense of pulling and a
•
loss of closeness when you shave. This is an indication that it is time
to replace your heads and cutters.
D
D
11
Advertisement
Table of Contents
