Table of Contents
Advertisement
4
Installation
4.1
Notes on safety for the installation
After carefully cleaning all around the area where the burner will
be installed, and arranging the correct lighting of the environ-
ment, proceed with the installation operations.
All the installation, maintenance and disassembly
operations must be carried out with the electricity
supply disconnected.
DANGER
4.2
Handling
The packaging of the burner includes a wooden platform, so it is
possible to move the burner (still packaged) with a transpallet
truck or fork lift truck.
With regard to the transport in the obligatory passages, refer to
the overall dimensions shown in Fig. 2, page 8.
The handling operations for the burner can be high-
ly dangerous if not carried out with the greatest at-
tention: keep any unauthorised people at a
distance; check the integrity and suitableness of the
WARNING
available means of handling.
4.3
Preliminary checks
Checking the consignment
After removing all the packaging, check the integrity
of the contents. In the event of doubt, do not use the
burner; contact the supplier.
CAUTION
The packaging elements (wooden cage or card-
board box, nails, clips, plastic bags, etc.) must not
be abandoned as they are potential sources of dan-
ger and pollution; they should be collected and dis-
posed of in the appropriate places.
4.4
Operating position
The burner is designed to operate only in posi-
tions 1, 2, 3 and 4 (Fig. 9).
Installation 1 is preferable, as it is the only one
WARNING
that allows the maintenance operations as
described in this manual.
Installations 2, 3 and 4 permit operation but
make maintenance and inspection of the com-
bustion head more difficult.
Any other position could compromise the cor-
rect operation of the appliance.
Installation 5 is prohibited for safety reasons.
DANGER
Installation
The installation of the burner must be carried out by
qualified personnel, as indicated in this manual and
in compliance with the standards and regulations of
WARNING
the laws in force.
Check also that the area in which you are working is empty and that
there is an adequate escape area (i.e. a free, safe area to which
you can quickly move if the burner should fall).
During the handling, keep the load at not more than 10" from the
ground.
After positioning the burner near the installation
point, correctly dispose of all residual packaging,
separating the various types of material.
Before proceeding with the installation operations,
CAUTION
carefully clean all around the area where the burner
will be installed.
The output of the burner must be within the boiler's
firing rate;
WARNING
A burner label that has been tampered with, re-
moved or is missing, along with anything else that
prevents the definite identification of the burner
WARNING
makes any installation or maintenance work diffi-
cult.
1
D7739
17
2
3
4
5
Fig. 9
20028248
Advertisement
Table of Contents
