Electrolux E5CM1-6ST Instruction Book page 6

• Do not use or place the appliance on a hot surface or near source of heat.
• Warning: Avoid spillage on the connector.
• Attention: The heating element surface is subject to residual heat after use.
• The mains cable must not come into contact with any hot parts of the appliance.
• This appliance is intended for domestic use only. The manufacturer cannot accept any
liability for possible damage caused by improper or incorrect use.
• Do not exceed the maximum filling volume as indicated on the appliance, as there is risk
of water tank water overflow from the back hole.
• Never operate appliance with open lid.
This appliances is intended to be used in household and
similar applications such as:
- staff kitchen areas in shops, offices and other working environments;
- farm houses;
- by clients in hotels, motels and other residential type environments;
- bed and breakfast type environments.
The surface with symbol
hot during use.
GETTING STARTED (Picture page 3)
1 Setting/changing time. Plug in the machine, the display will flash the initial time showing: 12:00. Press
the HOUR and MIN button to set the required time. Time can only be changed under standby mode,
cannot be changed under program/working mode. Simply press the HOUR and MIN button, the time
changes at once. Note: if you unplug the machine, the time needs so be set again.
2
Place the machine on a flat surface. When starting the machine for the first time, fill the tank with cold
water. Start the machine with the START/STOP button. Let a full tank of water pass through the machine
once or twice to clean it, without using paper filter or coffee.
3 Making coffee: open the lid and fill the water tank with fresh cold water up to the desired level. There is a
water level indicator on the water tank and on the coffee jug.
4
Insert a size 1x4 paper filter in the filter holder and fill it with ground coffee. For average strong coffee 6-7
g coffee powder per cup is sufficient. Close the water tank lid and place the jug back (complete with lid).
5
Setting/changing delay time. Press PROG button, the display will flash the initial time showing: 12:00
and a clock icon. Set hours by pressing the HOUR button. Then set minutes by pressing the MIN button.
Press the PROG button again to confirm, the display will stop flashing time and clock icon. Clock icon is
constant on and the display will go back to show the current time immediately. Note: If user don't press
HOUR or MIN or PROG button again, the display will go back to show the current time after 5 seconds,
and setting delay time is cancelled, clock icon will disappear.
6
Start the machine with the START/STOP button. The power indicator light will come on and hot water will
flow into the filter. If the machine is not turned off manually, the Safety Auto-Off function turns it off after
40 minutes.
7 If the jug is removed, the filter valve prevents coffee from dripping onto the warming plate. (While pre-
paring coffee, the jug must not be removed for longer than 30 seconds or the filter will overflow.)
8
The Aroma Selector extends the brewing time to maximize the flavour extraction and get a stronger cof-
fee for a small number of cups (normally less than 6).
9
The machine is compatible with Electrolux PureAdvantage
filter, it's recommended to change filter after 60 brew cycles. Before using the new filter, place the new
filter into a container of clean cool water, and let soak for 10 minutes. Then rinse the filter for 10 to 15
seconds under the running tap water.
6
: Caution, hot surface are liable to get
water filter. If you choose to use the water
TM
www.electrolux.com