National Instruments cRIO-908 Series Installation Instructions Manual
National Instruments cRIO-908 Series Installation Instructions Manual

National Instruments cRIO-908 Series Installation Instructions Manual

Rack mounting kit with din rail for compactrio and compactdaq

Advertisement

Quick Links

cRIO-9082

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the cRIO-908 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for National Instruments cRIO-908 Series

  • Page 1 cRIO-9082...
  • Page 2 Français Deutsch ni.com/manuals The National Instruments CompactRIO rack mounting kit with DIN rail is an accessory you can use to mount a CompactRIO chassis and other DIN rail-mountable equipment on a standard 19-inch rack. Note You need a #2 Phillips screwdriver to install the rack mounting kit.
  • Page 3 Installing the Rack Mounting Kit Complete the following steps to install the rack mounting kit on a standard 19-inch rack: Secure the bracket in position with four screws suitable for the rack. Screws are not included in the kit. Note Do not overtighten the screws.
  • Page 4 Connect the chassis ground wire to the bracket grounding screw. Refer to Figure 5 for the location of the bracket grounding screw. Install the top and bottom covers as shown in Figure 4. Figure 4. Installing the Top and Bottom Covers © National Instruments Corporation Rack Mounting Kit with DIN Rail for CompactRIO and CompactDAQ...
  • Page 5 Install cable ties (not included) to relieve strain on the cables if necessary. You can attach cable ties to the mounts on the top and bottom covers. Figure 5 does not show the top covers, but the top and bottom covers are identical. Rack Mounting Bracket Handles (2) Cable Entry/Exit Openings...
  • Page 6 Figure 7. Installing the Front Cover Tighten the four captive screws on the front cover. Do not tighten past 0.5 N m (4.9 lb in.) of ⋅ ⋅ torque. © National Instruments Corporation Rack Mounting Kit with DIN Rail for CompactRIO and CompactDAQ...
  • Page 7 For patents covering National Instruments products/technology, refer to the appropriate location: Help»Patents in your software, the patents.txt file on your media, or the National Instruments Patents Notice at ni.com/ patents. You can find information about end-user license agreements (EULAs) and third-party legal notices in the readme file for your NI product.

This manual is also suitable for:

Crio-9082

Table of Contents