Electric Shock Danger; Installation / Installation Instruction; Site Selection/Preparation; Wind Protection - Sanotechnik SANOSPA XXL1908 Instructions Manual

D. DANGER OF ELECTRIC SHOCK
The massage pool should be at least 1.5 m away from all iron objects to avoid electrostatic
discharge. If this is not possible, such objects must also be grounded!
2. INSTALLATION / INSTALLATION INSTRUCTIONS
A. SITE SELECTION / PREPARATION
Place the massage pool on a perfectly level surface. In the immediate vicinity there should be the
possibility of an electric and water connection and a drainage of water. If possible, place it so that
it is accessible from all four pages.
B.

WIND PROTECTION

Place the massage pool in the backyard, where there is not much windy!
C.

SUITABLE PLACE FOR INSTALLATION

Before installing the pool, check if there are any local regulations for placing the pools.
D.

TRANSPORTATION

Doors, stairs or passages can hinder you when the massage pool is set up to the desired location,
so make sure that the transport paths are free and wide enough.
E.

ELECTRICAL CABLE CONNECTION / SUPPLY

We recommend that you hire an electrician to connect to the electric network (connection to the
home network, as well as to connect the electronics to the massage pool itself).
• The massage pool must not be connected to a home network with a regular socket, except SPA
8 and 9, but with a stable electrical line, as it must be permanently connected to the electricity
- this way it can be prevented from freezing. If you do not follow the installation and connection
instructions, there may occur a damage to the massage pool and therefore a loss of warranty.
• When connecting, local regulations must be followed.
• There is a diagram on the control box cover (check the picture).
• The connection of the supply line must be correctly dimensioned and established by a local
electrician!
• To make the connection correct, use the intended connections inside the control box (see page 9).
• All wiring, including electrical, is pre-assembled. Do not drill additional holes or make any other
operations into the control box. If the control box is damaged, the warranty becomes invalid.
48 INSTRUCTION FOR USING THE SPA OUTDOORPOOL