Yamaha FX Nytro FX10D Owner's Manual page 51

1. Air valve cap
4. Install the hose connector of the shock
absorber pump onto the air valve of the
shock absorber, tighten it approximately
six turns until the pressure registers on
the pump gauge, and then pull the hose
connector lock lever up. NOTICE: Do not
overtighten the connector onto the air
valve as this will damage the connec-
tor seal.
[ECS00721]
1
2
1. Air valve
2. Hose connector
3. Hose connector lock lever
TIP
If the shock absorber has no air pressure, the
gauge reading will be zero.
5. To increase the air pressure, operate the
pump a few times. The pressure should
increase slowly. If the pressure increases
rapidly, check to make sure that the
pump is properly connected and tight-
1
3
Control functions
ened onto the air valve. To decrease the
air pressure, push the black bleed valve
button. NOTICE: Do not exceed 1406
kPa (14.1 kgf/cm², 200 psi).
1
150
10
15
5
20
0
R S
ACING HOX
bar
psi
1. Pressure gauge (high-pressure meter)
1. Bleed valve button
Air pressure range:
FX10M53S 773–1406 kPa (7.7–14.1
kgf/cm², 110–200 psi)
FX10M62S 773–1406 kPa (7.7–14.1
kgf/cm², 110–200 psi)
Recommended air pressure:
FX10M53S 1034 kPa (10.3 kgf/cm²,
150 psi)
FX10M62S 1034 kPa (10.3 kgf/cm²,
150 psi)
[ECS00981]
43