Table of Contents
Advertisement
Control functions
ened onto the air valve. To decrease the
air pressure, push the black bleed valve
button. NOTICE: Do not exceed 1406
kPa (14.1 kgf/cm², 200 psi).
1
50
40
60
psi
30
70
20
80
100
10
90
0
1. Pressure gauge (low-pressure meter)
1. Bleed valve button
Air pressure range:
FX10M53S 246–1406 kPa (2.5–14.1
kgf/cm², 35–200 psi)
FX10M62S 246–1406 kPa (2.5–14.1
kgf/cm², 35–200 psi)
Recommended air pressure:
FX10M53S 345 kPa (3.5 kgf/cm², 50
psi)
FX10M62S 345 kPa (3.5 kgf/cm², 50
psi)
42
TIP
To allow pressure to escape from the pump
and the shock absorber, push the button half-
[ECS00981]
way down and hold it. To allow only a small
amount of pressure to escape, push the but-
ton all the way down and quickly release it.
6.
Push the hose connector lock lever
down, and then remove the hose connec-
tor from the air valve.
TIP
When removing the connector, the sound of
air escaping may be heard, but this is from the
pump hose, not the shock absorber.
7.
Install the air valve cap.
TIP
If the shock absorber bottoms too easily or
rolls too much during cornering, increase the
air pressure by 34 kPa (0.3 kgf/cm², 5 psi). If
the shock absorber is too firm and you want a
more compliant ride, decrease the air pres-
sure by 34 kPa (0.3 kgf/cm², 5 psi).
Rear shock absorber
To adjust the air pressure
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Lift the rear of the snowmobile onto a suit-
able stand to raise the drive track off the
ground.
3.
Remove the air valve cap from the shock
absorber.
Advertisement
Table of Contents
