Table of Contents
Advertisement
Rebound damping force
The rebound damping force of each shock
absorber can be adjusted by turning its re-
bound damping force adjusting knob.
To increase the rebound damping force, turn
the adjusting knob in direction (a). To de-
crease the rebound damping force, turn the
adjusting knob in direction (b).
1. Rebound damping force adjusting knob
Rebound damping setting:
Minimum (soft):
19 click(s) in direction (b)*
Standard:
10 click(s) in direction (b)*
Maximum (hard):
1 click(s) in direction (b)*
* With the adjusting knob fully turned in
direction (a)
TIP
The damping forces will not decrease past the
minimum levels even if the adjusting knobs
are turned out more than the minimum set-
tings.
ESU13134
Adjusting the spring preload of the
center shock absorber and the rear
torsion springs
(FX10/FX10RTRS/FX10XT/FX10XT75)
The spring preload can be adjusted by turning
the adjusting nut on the center shock absorb-
er and the adjusters on the rear torsion
springs. Adjust the spring preload as follows.
Control functions
Center shock absorber
1.
Loosen the locknut.
2.
To increase the spring preload and there-
by harden the suspension, turn the ad-
justing nut in direction (a). To decrease
the spring preload and thereby soften the
suspension, turn the adjusting nut in di-
rection (b).
(b)
1. Spring preload adjusting nut
2. Distance A
3. Locknut
TIP
The spring preload setting is determined by
measuring distance A, shown in the illustra-
tion. The longer distance A is, the higher the
spring preload; the shorter distance A is, the
lower the spring preload.
1
3
2
(a)
39
Advertisement
Table of Contents
