Table of Contents
Advertisement
To adjust the air pressure
EWS00621
WARNING
Support the snowmobile securely on a
suitable stand before adjusting the shock
absorbers. Otherwise, the snowmobile
could fall and cause injury.
ECS00710
NOTICE
Make sure that there is no load on the
shock absorbers and that they are fully ex-
tended before making any air pressure ad-
justments.
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Lift the front of the snowmobile onto a
suitable stand to raise the skis off the
ground.
3.
Remove the air valve cap from the shock
absorber.
1. Air valve cap
4.
Install the hose connector of the shock
absorber pump onto the air valve of the
shock absorber, tighten it approximately
six turns until the pressure registers on
the pump gauge, and then pull the hose
connector lock lever up. NOTICE: Do not
overtighten the connector onto the air
valve as this will damage the connec-
tor seal.
[ECS00721]
Control functions
1
2
1. Air valve
2. Hose connector
3. Hose connector lock lever
TIP
If the shock absorber has no air pressure, the
gauge reading will be zero.
5.
To increase the air pressure, operate the
pump a few times. The pressure should
increase slowly. If the pressure increases
rapidly, check to make sure that the
pump is properly connected and tight-
ened onto the air valve. To decrease the
air pressure, push the black bleed valve
button. NOTICE: Do not exceed 1034
kPa (10.3 kgf/cm², 150 psi).
1
50
40
60
psi
30
70
20
80
100
10
90
0
1. Pressure gauge (low-pressure meter)
3
[ECS00733]
37
Advertisement
Table of Contents
