AEG Atlas Copco HBS 65 Instructions For Use Manual page 4

Switching the
machine on and
off
Dust extraction
Advice for
operation
Stationary device
(Accessory*)
ENGLISH
Intermittent use
Switching on: Press On-/off switch
Switching off: Release On-/off switch
Continuous use
Switching on: Press the On-/off switch and
then the locking button, after that release
on-off switch.
Switching off: Press the On-/off switch and
then release.
Always hold machine firmly with both hand
prior to switching on. Only switch on in
raised position.
Position the connection piece with the dust
bag over the machine outlet.
When suction performance becomes less
effective empty dust bag.
If large quantities of dust are being
produced, a hose-pipe can be connected
to the dustbag connector. Use the 26 mm
diameter Atlas Copco hose-pipe, which fits
the Atlas Copco wet-and-dry vacuum
cleaner as well as ordinary household
vacuum cleaners.
When sanding metal the dust suction
facility should not be used, because of the
risk of fire from flying sparks.
When sanding, guide the machine without applying special pressure. The weight of
the machine itself is quite sufficent for good sanding results.
By ataching the stationary mounting
device, sanding can be carried out both
horizontally and vertically. Screw the two
plastic parts together and fasten the longer
part to the uppermost side of the machine
with the capstan-head screw. Secure the
machine with the two clamps to a work
top.
*Not included in standard equipment,
available as an accessory.
3
2
1
HBS 65