Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Clemas & Co HS1100
Summary of Contents for Clemas & Co HS1100
- Page 1 HS1100 High speed Burnisher OPERATOR MANUAL Clemas & Co. Unit 5 Ashchurch Business Centre, Alexandra Way, Tewkesbury, Gloucestershire, GL20 8NB. Tel: 01684 850777 Fax: 01684 850707 Email: info@clemas.co.uk Web: www.clemas.co.uk...
- Page 2 THIS MANUAL CONTAINS VITAL INFORMATION FOR THE SAFE USE AND EFFICIENT OPERATION OF THIS MACHINE. CAREFULLY READ THIS OPERATOR’S MANUAL BEFORE STARTING THE MACHINE, AND RETAIN FOR FUTURE REFERENCE. INSTRUCT ALL OPERATORS TO READ THIS MANUAL. FAILURE TO ADHERE TO THE INSTRUCTIONS COULD RESULT IN SERIOUS BODILY ANJURI OR PROPERTY DAMAGE.
- Page 3 Delivery, instruction on safety rules, handling and maintenance as well as operation for the first time must be carried following the specification of this instruction book. The operator is responsi- ble for instructing the users. FURTHER SAFETY INSTRUCTIONS CONCERNING OPERATING AND MAINTENANCE ARE DETAILED IN THE RELEVANT SECTIONS AND MUST BE COMPLIED WITH! IMPORTANT NOTES Before starting to use the machine please observe the following points:...
- Page 4 Vibrations can damage the machine and is unsafe to operate. If the locking pad holder is not used, the pad will be thrown out from under the pad driver. Proper pad selection is important to achieve the desired performance of the machine and desi- red floor finish.
- Page 5 DRIVE BELT REPLACEMENT If replacement of the drive belt is necessary, use the following procedures: 1) Disconnect power cable from outlet (unplug machine). 2) Lock handle in the full upright position. 3) Tilt machine back and allow it to rest on the handle block and wheels. 4) Remove the protection carter.
- Page 6 TECNICAL CHARACTERISTICS POWER 1100 W PROTECTION CLASS LENGTH OF CORDS 15 m BRUSH SIZE 480 mm BRUSH REVS. 1100 \ 1500 rpm ENERGY SOURCE direct current VOLT 220 v WEIGHT 35 Kg DECIBEL 70 dB OPTIONAL (VACUUM ATTACHMENT) POWER 800 W AIR FLOW 51 L/s DEPRESSION...
- Page 7 GOODS TO BE RETURNED In case of goods to be returned for warranty replacement, it is necessary to have a written acceptance from FIORENTINI technical department before sending them. All defective parts must be carefully packed in order to avoid further damages during transport.
Need help?
Do you have a question about the HS1100 and is the answer not in the manual?
Questions and answers