Download Print this page

Advertisement

Quick Links

USER'S OPERATION MANUAL
Before operating this unit, please read this manual
thoroughly, and retain for future reference
WT5J1313DT
English

Advertisement

loading
Need help?

Need help?

Do you have a question about the WT5J1313DT and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Hisense WT5J1313DT

  • Page 1 USER’S OPERATION MANUAL Before operating this unit, please read this manual thoroughly, and retain for future reference WT5J1313DT English...
  • Page 3 0.03 1 kg. WT J1 1 0.03 5 0X6...
  • Page 6 water pressure from 0.03 MPa to 0.8 MPa. Appropriate tap Outlet end face Length of front end must be greater than 10mm. 1.Push slider down to remove hose joint from water inlet assembly, as shown in Fig. 2.Loosen 4 screws on hose joint properly and then connect hose joint to tap, as hose unavailable, loosen 4 screws and remove bush, as shown in Fig.
  • Page 7 2.Do not remove absorbing pad. Check if it falls off or has been damaged every time 10cm washing machine is going to be used. If yes, contact Hisense service department immediately. 3.Cut one part of the drain hose when it hose at proper is too long.
  • Page 8 10.5 .0 1 1.5- .0...
  • Page 9 5. Delay The Delay time is within 24 hours. When the Delay is set, the when the automatic process programming is performed again. Normal WT5J1 13DT Rinse+Spin 1. Power switch Press the power switch to turn on the power. Depending on the load of laundry to be washed, press this button After power-on, press the power switch to turn off the power.
  • Page 11: Troubleshooting

    Hisense department. Hisense Hisense abnormal. department. the third time, it is necessary to eliminate Hisense the main control board and department.