Husqvarna ST 424T Operator's Manual page 26

Hide thumbs Also See for ST 424T:
Table of Contents

Advertisement

Available languages

Available languages

Problem
Decreased power
The engine idles or runs
roughly
Excessive vibration / Han-
dle movement
The starter rope handle is
hard to pull
Loss of traction drive/
slowing of drive speed
Loss of snow discharge or
slowing of snow discharge
26
Possible cause
The spark plug cable is not connected.
The product throws too much snow.
The fuel tank cap is covered with ice or snow.
The muffler is dirty or clogged.
Improper cable length.
The muffler is blocked.
The air intake of the carburetor is blocked.
The fuel injector does not trigger.
The fuel line is blocked.
There is water in the fuel or the fuel is too old.
The fuel injector does not trigger.
Some parts are loose. The augers are dam-
aged.
The handles are not positioned correctly.
The adjustment lever nuts are loose.
The starter rope handle is frozen.
The starter rope is interfering with components.
The belt slips.
The belt is worn.
The belt is off the pulley.
The chute deflector is clogged.
Foreign objects clog the augers.
The shear pin is broken.
Excessive snow and ice build up in between
continous track components.
Solution
Connect the cable to the spark plug.
Decrease the speed and the width of
the swath.
Remove the ice and the snow on and
around the fuel tank cap.
Clean or replace the muffler.
Adjust the cable.
Make sure that the engine is cool.
Clear the blockage.
Make sure that the engine is cool.
Clear the blockage.
Contact an authorized service center.
Clean the fuel line.
Empty the fuel tank and carburetor.
Fill the fuel tank with fresh, clean
gasoline.
Contact an authorized service center.
Tighten all fasteners. Replace the
damaged parts. If vibration remains,
contact an authorized service center.
Make sure that the handles are
locked into position.
Tighten the nuts until the handle feels
safe.
Slowly pull out as much rope out of
the starter as possible and release
the starter rope handle. If the engine
does not start, repeat the procedure
or use the electrical starter.
The starter rope should not touch any
cables or hoses.
Adjust the cable. Adjust the belt.
Check / replace the belt. Adjust the
pulley.
Check / reinstall the belt. Adjust the
pulley.
Clean the chute deflector.
Remove the debris or the foreign ob-
ject from the augers.
Replace the broken shear pin.
Remove snow and ice build up from
in between continous track compo-
nents.
876 - 019 - 05.10.2023

Advertisement

Table of Contents
loading

This manual is also suitable for:

St 427St 430St 424St 427tSt 430t

Table of Contents