Electromagnetic Compatibility - Eclipse 1000 User Manual

Electromagnetic Compatibility

This equipment has been tested and found to comply with the limits for medical
devices to the IEC60601-1-2: 2001-09 Electromagnetic Compatibility standard.
These limits are designed to provide reasonable protection against harmful
interference in a typical medical installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed according with the instructions,
may cause harmful interference to other devices in the vicinity. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to other devices, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving device.
I
Increase the separation distance between the equipment.
I
Connect the equipment into an outlet on a circuit different from that which
I
the other device(s) are connected.
Consult the manufacturer or service technician for help.
I
Guidance and Manufacturer's declaration - electromagnetic emissions
The SeQual Technologies ECLIPSE Oxygen System is intended for use in the
electromagnetic environment specified below. The customer or the user of the
SeQual Technologies ECLIPSE Oxygen System should assure that it is used in
such an environment.
Emissions Test
RF emissions CISPR 11
RF emissions CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions IEC 61000-3-3
48 | ECLIPSE
TM Model 1000 User Manual
Compliance Electromagnetic Environment - Guidance
Group 1 The SeQual Technologies ECLIPSE Oxygen
System uses RF energy only for its internal
function. Therefore, its RF emissions are
very low and are not likely to cause any
interference in nearby electronic equipment.
Class B The SeQual Technologies ECLIPSE Oxygen
System is suitable for use in all establishments,
including domestic establishments and those
Class A
directly connected to the public low-voltage
power supply network that supplies buildings
used for domestic purposes.
Complies