Working On Your Computer; Safety Instructions; Turning Off Your Computer - Windows 10; Before Working Inside Your Computer - Dell 8DEHV7YR Service Manual

Table of Contents

Safety instructions

Use the following safety guidelines to protect your computer from potential damage and to ensure your personal safety. Unless otherwise

noted, each procedure included in this document assumes that the following conditions exist:

•

You have read the safety information that shipped with your computer.

•

A component can be replaced or, if purchased separately, installed by performing the removal procedure in reverse order.

WARNING:

Disconnect all power sources before opening the computer cover or panels. After you finish working inside the

computer, replace all covers, panels, and screws before connecting to the power source.

WARNING:

Before working inside your computer, read the safety information that shipped with your computer. For additional

safety best practices information, see the Regulatory Compliance Homepage at www.Dell.com/regulatory_compliance

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple

repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.

Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions

that came with the product.

CAUTION:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an

unpainted metal surface at the same time as touching a connector on the back of the computer.

CAUTION:

Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its

edges or by its metal mounting bracket. Hold a component such as a processor by its edges, not by its pins.

CAUTION:

When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have

connectors with locking tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the

cable. As you pull connectors apart, keep them evenly aligned to avoid bending any connector pins. Also, before you connect a

cable, ensure that both connectors are correctly oriented and aligned.

NOTE:

The color of your computer and certain components may appear differently than shown in this document.

Turning off your computer — Windows 10

CAUTION:

To avoid losing data, save and close all open files and exit all open programs before you turn off your computer or

remove the side cover.

Click or tap

and then click or tap Shut down.

NOTE:

Ensure that the computer and all attached devices are turned off. If your computer and attached devices did not

automatically turn off when you shut down your operating system, press and hold the power button for about 6 seconds to

turn them off.

Before working inside your computer

To avoid damaging your computer, perform the following steps before you begin working inside the computer.

Ensure that you follow the

Ensure that your work surface is flat and clean to prevent the computer cover from being scratched.