Table of Contents
Advertisement
The table holder below the table board is
constructed so that is can swivel. You can
adjust the table board to your needs.
– Loosen the clamp by turning the locking
bolt (6).
– Swivel the table board into the desired
position and clamp it tight again by
turning the locking bolt (6).
Note: The locking bolts used at the swivel
table can hinder each other during the
turning. In this case, pull the respective
lever in the direction of the arrow and
swivel it into the desired position. After
releasing the level, it snaps back into
position.
Warning! Position the locking bolt
(4) at the lower holder so that the grip
points downwards. This prevents injuring
a foot by bumping and you also don't get
caught by your trouser leg.
Folding back the swivel tables
The tables are folded back by following the
steps in reverse order.
Then replace the table board (1) and the
table leg (2) back into the holders provided.
Note: The unfolded tables can take a
maximum load of 10 kg.
Operation
25
Advertisement
Table of Contents
