Table of Contents
Advertisement
Manual_FCS-C500_V1.1_EN
7. Controller Connector
Connect the stack cables to the lead wires of the T-sensor/
blower/purging valve/input valve on the controller.
8. Controller
Controls the stack temperature, blowers, hydrogen input,
purging and short circuiting of the stack.
9. H2 output & H2 Input
H2 output: connect the tube shown in 11 below.
H2 input: connect the tube shown in 11 below with the
hydrogen pressure between 0.45-0.55Bar.
.
10. Fuel Cell +/Fuel Cell-& Load - Connectors
FC+ of the controller is connected to the fuel cell positive
pole.
FC- of the controller is connected to the fuel cell negative
pole.
11. Tube for H2 Input and Output
The tube with 6mm outer diameter and 3mm inner
diameter is connected to the H2 IN as in 9 above and to
the input valve of the hydrogen source. H2 output tube
with 6mm outer diameter and 3mm inner diameter is
connected to the purging valve on one end and the H2
OUT the other.
12 . Fittings
For connecting the load.
11
Advertisement
Table of Contents
