en Rinse aid system
If rinse aid spills out, remove it
3.
from the tub.
Spilled rinse aid can cause ex-
cessive frothing during the wash
cycle.
Close the lid of the dispenser for
4.
rinse aid.
a The lid clicks into position.
Setting the amount of rinse
aid
If there are streaks or water marks on
tableware, change the amount of
rinse aid.
Press .
1.
Hold programme button A and
2.
press
repeatedly until the dis-
play shows H:xx.
Release programme button A and
3.
.
a Programme button A flashes and
the display shows H:04.
Press programme button A re-
4.
peatedly until the display shows
the value set at the factory r:05.
Press programme button C re-
5.
peatedly until the right amount of
rinse aid has been set.
– A low setting adds less rinse aid
during the wash cycle and re-
duces streaking on tableware.
32
– A higher setting adds more
Press
6.
max
Switching rinse aid system off
If you find the rinse aid refill indicator
irritating, e.g. when using combined
detergents with a rinse aid compon-
ent, you can switch the rinse aid sys-
tem off.
Tip: The function of rinse aid is lim-
ited with combined detergents. You
will generally get better results using
rinse aid.
Press .
1.
Hold programme button A and
2.
press
play shows H:xx.
Release programme button A and
3.
a Programme button A flashes and
the display shows H:04.
Press programme button A re-
4.
peatedly until the display shows
the value set at the factory r:05.
Press programme button C re-
5.
peatedly until the display shows
r:00.
Press
6.
a The rinse aid system is switched
off and the rinse aid refill indicator
is deactivated.
rinse aid during the wash cycle,
reduces water marks and im-
proves the drying result.
to save the setting.
repeatedly until the dis-
.
to save the setting.