en Water softening system
¡ Special salt can damage the tub
due to corrosion.
To make sure that any special
▶
salt that escapes is washed out
of the tub, add the special salt
to the dispenser for special salt
immediately before the pro-
gramme starts.
Unscrew the lid of the dispenser
1.
for special salt and remove.
On initial start-up: Fill the dispenser
2.
right up with water.
Note: Only use special salt for
3.
dishwashers.
Do not use salt tablets.
Do not use table salt.
Add the special salt to the dis-
penser.
1
Funnel
Fill the dispenser right up with spe-
cial salt. The water in the dis-
penser is displaced and forced
out.
Place the lid back on the dis-
4.
penser and turn to close.
1
Depending on the appliance specifications
30
Switching off water softening
system
Note
To avoid damage to the appliance, only
switch off the water softening system in
the following cases:
¡ The water hardness is max. 26 °E
¡ The water hardness is 0 - 8°°E.
1.
2.
a
3.
a Programme button A flashes and
4.
5.
a The water softening system is
Regeneration of the water
softening system
In order to obtain fault-free function of
the water softening system, the appli-
ance performs reheating of the water
softening system at regular intervals.
Regeneration of the water softening
system takes place before the end of
the main rinse cycle in all pro-
and you are using combined deter-
gents with salt replacement sub-
stances. According to manufactur-
ers, combined detergents with salt
replacement substances can gen-
erally only be used up to a water
hardness of 26°°E without adding
special salt.
You do not need to use special
salt.
Press .
Hold programme button A and
press
repeatedly until the dis-
play shows H:xx.
Release programme button A and
.
the display shows H:04.
Press programme button C re-
peatedly until the display shows
H:00.
Press
to save the setting.
switched off and the salt refill indic-
ator is deactivated.