Advertisement
4-3.Connecting a SAS device
To connect a SAS device.
1.
Confirm the power to the server is off (System POWER LED off), then unplug the power cord
from the electrical outlet.
2.
Insert a SAS cable connector in this product's connector fully for firm connection.
3.
Insert a cable connector (the other side) in SAS device's connector fully for firm connection.
4.
Plug the power cord of the server into the electrical outlet.
4-4.Install the Driver
To use this product, the appropriate SAS driver for your operating system must be installed. For
detailed information, refer to the Maintenance Guide of the server.
Do not connect this product to a server or SAS device that is not recommended by
NEC Corporation. If the product is connected to a server or SAS device that is not
recommended by NEC Corporation, the product may malfunction or fail.
Please contact the retailer or service center for the information on recommended
servers, SAS devices, or SAS cables.
If the power to the server is on (System POWER LED on), shut down the operating
system and then turn off the server.
Advertisement
