Table of Contents
Advertisement
RHEA V8100S2
1. Make sure that the antenna has a clear view of
the sky in order to receive satellite signals.
2. Turn on the receiver and the TV set. For details
about the use of the receiver and the TV set,
please refer to the relevant user manuals pro-
vided by the manufacturers.
3. On the control unit, by means of the relevant
selector (A), select
(ASTRA2, ASTRA1, HOTBIRD).
4. Turn on the control unit (set (B) key to ON).
5. After a few seconds, the led (C) turns red, and
this means that the antenna is searching for the
signal.
6. If the antenna has found a satellite signal, the
led turns orange and starts checking that the
found satellite is the selected one. Verification
can take up to 30 seconds.
7. If, after a few seconds, the led turns green, it
means that the found satellite was the correct
one. Otherwise, the led turns red again, and the
procedure is restarted.
8. With green led, after a few seconds, the image
will appear on the TV set. Follow the instruc-
tions appearing on the screen to set the param-
eters for a correct operation of the receiver.
9. Automatic stand-by function:
once the satellite has been verified (green led
on the control unit), after about 2 minutes that
the boat did not move, the antenna stops in the
position where signal reception from the satel-
lite is maximum.
A level decrease of the received signal or a total
shift of the boat of 6° in two minutes "wake the
antenna up" in order that it recovers the maxi-
mum receivable signal level.
S
WARNING
If the led flashes alternately red and green, this
means that the antenna is not connected to the
control unit or that a failure has occurred. See sec-
tion "Troubleshooting" or contact the Service Cen-
tre.
the desired satellite
56
Fig. 23
A. Satellite selector
B. Power on key
C. Led
www.glomex.it
Advertisement
Table of Contents
